Download Print this page

Operating Instructions; Troubleshooting; Illustrations; Cleaning/Maintenance - Holmes HCH41251 Owner's Manual

Twin ceramic heater

Advertisement

OPERATING INSTRUCTIONS

Your heater is equipped with a technologically advanced 1 Touch
electronic thermostat. You can set the heater to run continuously in
manual mode or set the 1 Touch
temperature setting. The 1 Touch
the heater ON or OFF depending on the preset comfort level. The com-
fort level ranges between 60º and 80º Fahrenheit.
Manual Mode Instructions:
1. Plug the heater into a 120V AC electrical outlet.
2. To start the unit, push the MODE/OFF button once for the HIGH
(1500 Watts) manual setting. (See fig. #1 and #2)
3. Press the button again for the LOW (1000 Watts) manual setting.
(See fig. #1 and #2)
4. To stop the unit, press and hold the button for two seconds or keep
pressing the button until all the temperature indicators are OFF.
Note: The Power Light will remain lit during operation. In Manual
Mode, only the LOW or HIGH power light will be lit.
TM
1 TOUCH
THERMOSTAT INSTRUCTIONS
To take advantage of the 1 Touch
MODE/OFF button until the desired temperature is set in either the HIGH
(1500 Watt) or LOW (1000 Watt) setting. When ambient temperature
rises above the set temperature, the heater will stop. When the ambient
temperature drops below the set temperature, the heater will turn on
automatically.
TM
Note: When the 1 Touch
thermostat is set, either the HIGH or LOW
power light, and the set temperature light will remain lit during
operation. (See fig. #1 and #2)
Note: It is normal for the heater to cycle ON and OFF as it maintains the
preset temperature. To prevent the unit from cycling, you need to raise
the thermostat setting.

ILLUSTRATIONS

Figure 1
A. POWER LIGHTS
B. MODE/OFF CONTROL
C. TEMPERATURE SET LIGHTS
D. CARRY HANDLE (NOT VISIBLE)
TM
Thermostat to your desired
TM
thermostat will automatically turn
TM
Thermostat continue to press the
B
C
A
Note: 1 Touch
TM
has memory. The 1 Touch
the previous temperature setting after the unit has been turned off.
However, if the unit is unplugged, the 1 Touch
and will no longer remember the previous temperature setting.
TM

CLEANING/MAINTENANCE

During Season Care:
Always unplug the heater, before moving or cleaning.
1. Carefully wipe the unit with a soft, damp cloth. Please be very
cautious near the motor and heating elements.
2. NEVER use abrasive or flammable solvents to clean the unit.
3. After cleaning, be sure to completely dry the unit with a
cloth or towel.
After Season Care:
1. Store heater in a cool, dry location.
2. Holmes recommends that you store the unit in its original carton.

TROUBLESHOOTING

If your heater fails to operate:
• Make sure the electrical outlet or circuit breaker is working.
• Check for obstructions. If you find an obstruction turn the heater OFF,
and UNPLUG THE UNIT. Carefully remove the obstruction and follow
the reset instructions.
• The thermostat might be set too low. Press the MODE/OFF button
until the heater restarts.
Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions.
Figure 2
D
A. SET TEMPERATURE LIGHT
B. LOW POWER (1000 WATTS)
C. HIGH POWER (1500 WATTS)
D. MODE/OFF CONTROL
TM
thermostat will remember
TM
thermostat will be reset
CONTROL PANEL CLOSE-UP
B
/Off
A
C
D

Hide quick links:

Advertisement

loading

This manual is also suitable for:

1 touch hch4125