Table of Contents
Advertisement
I
NTRODUCTION
Symbols Used in this Manual
The following is the description for the symbols used in this manual. Description refers to:
TV FUNCTIONS
: Analog TV operation
TV
: Digital TV operation
DTV
• If neither symbol appears under the function heading,
operation is applicable to both.
Supplied Accessories
remote control
(RM-C-2155)
• If you need to replace these accessories, please refer to the model name and parts name with the illustrations and
call our toll free customer support line found on the cover of this manual.
Attaching the Stand
You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper
direction.
1
Spread a thick and soft cloth over a
table as shown below.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least two people are required at
this step.
To remove the stand from this unit
Unscrew the screws indicated by above "
the screws are removed pull the stand up toward the rear of the
unit. Be careful not to drop the stand when you remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
4
EN
batteries (AA x 2)
cable
management tie
2
Insert the neck under the bottom
of the main unit to the stand's hole
(shown by arrow
➁
" screw holes. After
BLURAY FUNCTIONS
: Playback of BD-video
BD
: Playback of DVD-video
DVD
: Playback of audio CD
CD
• If none of symbol appears under the function heading,
operation is applicable to all.
screw kit for
attaching the stand
3
➀
).
➀
AC power cord
Drive screws in the 4 threaded holes
at the bottom of the stand until
they are tight.
➁
➁
screw holes
screw holes
Advertisement
Table of Contents
Troubleshooting
