Maintenance - Vector 7” RANDOM ORBITAL WAXER Owner's Manual & Warranty Information

WAX REMOVAL
1. Once the wax has thoroughly dried to a white haze, it can be removed. A second terry cloth
"Wax Off" bonnet is provided for wax removal. This is the reversible terry cloth bonnet
without the plastic liner. Install this bonnet as described earlier and the polisher is ready for
wax removal.
2. Follow the same long sweeping strokes in a criss-cross figure-eight motion previously
described, gliding the polisher over the surface, again permitting the weight of the unit to do
the work.
3. Occasionally it becomes necessary to remove the bonnet and shake out the dried polish
residue. A bonnet laden with wax residue will bring about streaks on the surface.
4. After removing the wax from all the major flat surfaces, use the edge of the pad to reach the
curved or concave surfaces.
5. Small areas, such as near and around mirrors, should be finished by hand.
FINISH POLISHING
1. A third "Polishing" bonnet is provided with your Vector polisher, designed to generate that
professional gleaming finish. This is the smooth foam padded "baby diaper" bonnet. Install
this bonnet as described earlier and your polisher is ready for polishing.
2. Follow the same figure-eight motion described previously, gliding the polisher over the
surface, again permitting the weight of the unit to do the work.
3. Small areas such as near and around mirrors should be finished by hand.

MAINTENANCE

• All bonnets can be cleaned by hand washing in warm soapy water. Allow bonnets to fully
dry before use
WARNING: DO NOT IMMERSE THE FOAM PAD OR POLISHING UNIT IN WATER.
1. When storing this polisher, store with the pad up, as this will prevent the foam pad from
compressing or being set in a wrong position.
2. All plastic parts should be cleaned with a soft damp cloth. NEVER use solvents when cleaning
any plastic part as this may damage the finish.
WARNING: DO NOT at any time let Gasoline, Brake Fluids or any petroleum-
based products come in contact with plastic parts or power cord.
They contain chemicals that can damage, weaken or destroy plastic
and insulation.
6
VEC261-7" manual 12/23 6 1/21/03, 4:47 PM