Service And Parts; Operation - Vector 7” RANDOM ORBITAL WAXER Owner's Manual & Warranty Information

SERVICE
1. Only qualified repair personnel must perform tool service. Service or maintenance performed
by unqualified personnel could result in a risk of injury.
2. When servicing a tool, use only identical replacement parts. Follow instructions in the
maintenance section of this manual. Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of electric shock or injury.
WARNING: NO USER - SERVICEABLE COMPONENTS INSIDE
OPENING UNIT WILL VOID WARRANTY!
INTRODUCTION
Congratulations on selecting the Vector 7" Random Orbit Waxer. You can now obtain a profes-
sional shine with a higher luster than imaginable by hand. Lightweight and easy to use, the
Vector 7" Random Orbit waxer/polisher imitates a hand polishing motion leaving an even
finish with no hot spots, streaks or swirls. The action is ideal for delivering a loster that
ordinarily takes hours to produce by hand. The random orbital movement of the Vector polisher
oscillates as it rotates so burns, streaks and swirl marks are no longer a problem if the
guidelines for use are strictly followed.
• Ideal for buffing Cars, Boats, Trucks, SUV's and Recreational Vehicles
• Powerful, high performance, quiet running motor makes polishing quick and easy
• Safe for all finishes, lightweight and easy to use

SERVICE AND PARTS

For ser vice and parts contact the Vector Customer Ser vice Depar tment at:
VECTOR Manufacturing, Ltd. 4140 SW 28th Way, Ft. Lauderdale, 33312
Tel: (866) 584-5504 • Fax: (954) 584-5556
• Only qualified repair personnel must perform tool service.
• Use only identical replacement parts. Follow instructions in the Maintenance section of this
Owners manual. Use of unapproved parts or failing to follow Maintenance Instructions may
produce the danger of electrical shock, injury and will void the product warranty.
WARNING:
The use of unapproved parts or accessories not recommended with this power tool might
produce a dangerous condition.

OPERATION

SURFACE PREPARATION
• Wash your car or surface thoroughly to remove all dirt and oil. Pay special attention to
areas that capture excessive layers of dirt such as, areas around wheel wells and next to
bumpers. It is very important that your car be clean and dry before applying wax. Any wax
protection will wear longer and protect better if applied directly to the paint.
• After washing, move the car or surface you're working on to a dry area out of direct sunlight
and allow the surface to dry and cool.
WAX APPLICATION
WARNING: DISCONNECT POLISHER FROM POWER BEFORE CHANGING BONNETS
• With the foam pad facing up, attach the smooth "Wax on" applicator bonnet (bonnet with
the plastic liner), making sure the bonnet is centered on the foam head.
4
VEC261-7" manual 12/23 4 1/21/03, 4:47 PM