Troubleshooting; Safe Battery Disposal; Bulb Replacement; Dc Plug Fuse Replacement - Vector Stormtracker Series User's Manual & Warranty Information

VEC191_Manual_041806_R 4/18/06 6:17 PM
WARNING
To reduce the risk of shocks or burns and avoid damage to the unit,
make sure all power switches are in the OFF position, all adapters are
unplugged and the unit has been allowed to cool down before
performing any cleaning or parts replacement.

Bulb Replacement

1. Remove the rubber bezel on the rim of the Spotlight to reveal eight small Phillips
screws in the retaining ring.
2. Using a screwdriver, remove (counterclockwise) the screws and set them aside.
3. Lift off the retaining ring, glass lens and rubber "O" ring and set them aside.
4. Carefully remove the reflector and bulb assembly.
5. Disconnect the bulb from the guarding wires and replace the burned out bulb
with one of the same type listed in the Specifications section of this manual.
6. Reassemble the guarding wires, put back the reflector, rubber "O" ring and
the lens.
7. Replace rubber bezel by sliding forward to the front of the spotlight.
8. Turn one of the Spotlight's ON/OFF switches to the ON position to ensure
proper operation.

Battery Replacement

1. Release the battery compartment cover locks on either side of the unit and
remove the cover.
2. Pull out the (two) batteries.
3. Disconnect the terminals and replace the batteries with the same type listed in
the Specifications section of this manual.
4. Replace the battery compartment cover and engage the locks.
5. Turn one of the Spotlight's ON/OFF switches to the ON position to ensure
proper operation.
Page 6
6

Safe Battery Disposal

Contains a maintenance-free, sealed, non-spillable, lead acid battery,
which must be disposed of properly. Recycling is required, contact your
local authority for information. Failure to comply with local, state and
federal regulations can result in fines, or imprisonment. For more
information on recycling this battery, call toll-free (877) 288-7722.

DC Plug Fuse Replacement

The fuse in the DC plug protects the charging circuit of the 12 Volt DC Power/
Charging Adapter. If AC recharging works, but the DC charging does not, then the
fuse may be opened (blown).
To replace the fuse:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate replacement fuse with same type and rating.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN.
7. Test for proper operation of the 12 Volt DC Power/Charging Adapter.

TROUBLESHOOTING

No Charge Indicator Light When Charging
1. Check connection to the AC Recharge Port
2. Check connection to AC adapter
3. Confirm there is a functioning AC or DC current
Spotlight Will Not Operate
1. When charging using the 120 volt AC method, the Spotlight will not operate.
Be sure all adapters are disconnected before Spotlight usage.
2. If you suspect the bulb is blown, check the filament. If the filament is coiled and
unbroken, the bulb is not blown. If filament is blown, replace bulb as directed
on page 6.
Unit Will Not Operate
1. If the unit does not operate, the battery may be completely discharged. Charge
the unit following the directions on page 3.
2. If the unit does not operate after recharging as directed:
• Replace the two 6 volt, 6.0 Ah batteries as directed on page 6.
• Check the main fuse and, if necessary, replace it with a new 20 amp spade
fuse (see page 2 for illustration).
7