Care And Maintenance; Using The Spotlight; Using The 3-Led Auxiliary Light; Using The 12 Volt Dc Accessory Outlet - Vector Stormtracker Series User's Manual & Warranty Information

VEC191_Manual_041806_R 4/18/06 6:17 PM
CAUTION
Before charging/recharging the unit's battery, make sure all power
switches are in the OFF position.
OPERATING INSTRUCTIONS
Powering the Unit
The Storm Tracker can be operated using either the internal rechargeable batteries
™
(for cordless use) or the 12 Volt DC Power/Charging Adapter. See the "Charging the
Battery" section before using the unit in cordless mode.

Using the Spotlight

The quartz halogen Spotlight is operated by the two
switches located on the side of the unit. The top
ON/OFF Switch controls the high beam (100 watt)
function; the bottom ON/OFF Switch controls the low
beam (approx. 50 watt) function.
The Spotlight will run for 60 minutes on low beam setting and 35-40 minutes on high
beam setting on a single charge.

Using the 3-LED Auxiliary Light

The 3-LED Auxiliary Light is operated by the LED Auxiliary Light ON/OFF Pushbutton
located on the top of the grip handle. The LED Auxiliary Light will run for 250 hours
on a single charge.

Using the AM/FM Radio

The Radio Band Selector Switch (see "Radio Control Panel Detail" on page 2)
controls the radio's ON/OFF function and allows the user to select AM, FM or
"Weather" frequency.
• After sliding the Radio Band Selector Switch to desired frequency, rotate the Radio
Tuner Dial to search for a station.
• Adjust volume using the Volume Knob.
• Insert the headphones (not supplied) into the Headphone Jack if private listening
is desired.

Using the Weather/Emergency Radio

The Storm Tracker ™ 10,000,000 Power Series
Radio/Spotlight receives all of the National Oceanic and Atmospheric
Administration (NOAA) weather channels, plus National Weather Service
warnings, watches and forecasts, and other non-weather related emergency
warning system broadcasts.
• Slide the Radio Band Selector Switch to "Weather."
• Rotate the Radio Tuner Dial to search for a station.
• Adjust volume using the Volume Control Knob.
• Insert headphones into the Headphone jack if private listening is desired.
Alert Function
The Alert function is only available when "Weather" has been selected on the Radio
Band Selector Switch.
Page 4
™ All Weather AM/FM
4
• Using the Radio Tuner Dial, select the desired weather station.
• Press the Alert ON/OFF pushbutton located on the top of the unit (see Figure 1).
• The green Alert ON/OFF LED will light, indicating this function is operating. The
weather station will remain muted until a weather alert is detected and then an
alarm siren will sound briefly.
ALERT ON/OFF LED
ALERT ON/OFF
PUSHBUTTON
Alarm Function
The Alarm function is only available when "Weather" on the Radio Band Selector
Switch and "Alert" mode have been selected
• Using the Radio Tuner Dial, select the desired weather station.
• Press the Alert ON/OFF pushbutton and Alarm/Lock pushbutton located on the
top of the unit (see page 2).
• The green Alert ON/OFF LED and green Alarm/Lock LED will light, indicating this
function is operating. The weather station will remain muted until a weather alert
is detected and then an alarm siren will sound continuously until the Alert
ON/OFF or Alarm/Lock pushbutton is pushed again.

Using the 12 Volt DC Accessory Outlet

The 12 volt DC accessory outlet powers any DC appliance that does not exceed
5 amps. Flip up the accessory outlet cover and insert the appliance's DC plug. Close
the cover after use.

Using the Adjustable Workstand

Set the hands-free adjustable workstand to the desired position; then turn the knobs
on either side of the unit to lock in position.

CARE AND MAINTENANCE

All batteries lose charge with time. AC recharge is recommended after each use or
every two months when not in frequent use. Use the supplied 120 Volt AC Charging
Adapter and charge for the recommended time.
If the unit gets dirty, gently clean the outer surfaces of the Spotlight with a soft cloth
moistened with a mild solution of water and detergent. Periodically inspect the
condition of charging adapters, connectors, and cords. Replace any components
that may have become worn or broken.

Replacement Parts

The quartz halogen bulb and sealed lead acid batteries are available through Vector
Manufacturing. A comparable (12 volt H4 100 watt) bulb may be substituted. These
can also be purchased from popular automotive parts suppliers nationwide. Contact
Vector Manufacturing's Technical Support Department for replacement parts
(including replacement adapters and cords) and any additional information that you
may need. They may be reached at (954) 584-4446 or toll free at (866) 584-5504.
ALARM/LOCK LED
ALARM/LOCK
PUSHBUTTON
5