Sony MZ-NHF800 Service Manual page 2

MZ-NH700/NHF800
Battery life
When recording continuously
Hi-MD mode (When using a 1GB Hi-MD disc)
3)
(Unit: approx.hours)(JEITA
Batteries Linear Hi-SP Hi-LP
PCM
NH-7WMAA
3 4.5 5
4)
5) 2.5 3.5 4.5
LR6
3) Measured in accordance with the JEITA (Japan Electronics and
Information Technology Industries Association) standard.
4) When using a 100% fully charged nickel metal hydride rechargeable
battery
5) When using a Sony LR6 (size AA)
"STAMINA" alkaline dry battery (produced in Japan)
Hi-MD mode (When using a 60/74/80-minute standard disc)
(Unit: approx.hours)(JEITA)
Batteries
Linear Hi-SP Hi-LP
PCM
NH-7WMAA 2.5 4.5 5.5
LR6 5 8 9.5
MD mode
(Unit: approx.hours)(JEITA)
Batteries
SP LP2 LP4
Stereo Stereo Stereo
NH-7WMAA 4.5 6 6.5
LR6 7.5 9.5 11
When playing continuously
Hi-MD mode (When using a 1GB Hi-MD disc)
(Unit: approx.hours)(JEITA)
Batteries Linear Hi-SP Hi-LP
PCM
NH-7WMAA 4.5 7.5 9
LR6 11 18.5 21.5
Hi-MD mode (When using a 60/74/80-minute standard disc)
(Unit: approx.hours)(JEITA)
Batteries
Linear Hi-SP Hi-LP
PCM
NH-7WMAA
4 7.5 9
LR6 9.5 17 20
MD mode
(Unit: approx.hours)(JEITA)
Batteries SP LP2 LP4
Stereo Stereo Stereo
NH-7WMAA 7.5 9 10
LR6 20.5 24 26
When using the radio (MZ-NHF800)
(Unit: approx.hours)(JEITA)
Batteries FM/AM TV/Wb
(weather) 6)
NH-7WMAA 7.5 7
LR6 18.5 17
6) USA model only.
On power sources
•
For use in your house: use the AC power adaptor supplied with this
recorder. Do not use any other AC power adaptor since it may cause the
recorder to malfunction.
Polarity of the plug
Supplied accessories
AC power adaptor (1)
Remote control (1)
Headphones (for USA model) (1)
Earphones (except USA model) (1)
Dedicated USB cable (1)
NH-7WMAA Nickel metal hydride rechargeable battery (1)
CD-ROM (SonicStage/MD Simple Burner (1)*
Battery carrying case (1)
Carrying pouch (except USA model)
Optical cable (MZ-NH700) (except Canadian andMexican Models) (1)
Clamp filter (2)
*Do not play a CD-ROM on an audio CD player.
Design and specifications are subject to change without notice.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
2
)
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR
LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES
PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE
FONCTIONNEMENT. NE REMPLACER CES COM- POSANTS
QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT
DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS
PUBLIÉS PAR SONY.