Oil Circulation Blower - Buffalo B100 Owner's Installation And Operation Manual

Annual Stove Maintenance
Before firing the stove for the first time each
heating season, perform all of the above
maintenance/cleaning procedures; in addition,
perform the following two simple maintenance
procedures.
NOTE: It is extremely important to thoroughly
inspect and clean the exhaust system prior to
the beginning of the each heating season.
This must be done to both clean any
accumulated ash and/or soot that may have
accumulated, but also to confirm that it is free
of any obstructions, such as bird or rodent
nests which will have a significant detrimental
effect on the performance of the appliance.
• Shut down stove and let it cool a
minimum of 60 minutes.
• Once stove has cooled for 60 minutes,
toggle the on/off toggle switch to the
off position.
• Unplug the power cord from the back
of the stove (as identified in the Daily
Stove Maintenance procedure above)

Oil Circulation Blower

• Remove Right Side Panel
o Loosen the two screws (if your side
panel is slotted) or remove the two
screws (if your side panel has
holes) at the back of the right side
panel of the stove (right as you are
looking at the stove from the front)
that hold the right side panel in
place.
o Open the burn chamber door and
heat exchanger door.
o Pull the back of the right side panel
away from the stove 1" to 2".
o Push forward on the side panel
(toward the front of the stove) to
free it from the stove; you may
need to "bump" the side panel
forward with the palm of your hand
to free it.
• Locate the oil port on the circulation
blower (Figure 25)
Figure 25
• Place two drops of oil into the oil port
on the circulation blower
• Reinstall Right Side Panel
o Open the burn chamber and heat
o Holding the rear of the side panel
o Keeping the rear of the side pane 1
o Holding the front of the panel flush
o After the front of the panel is
o Reattach the back of the side panel
Page 32 of 37
exchanger doors.
1" to 2" away from the side of the
stove, position the front of the
panel around the door latch.
to 2" away from the side panel of
the stove, slide the panel forward
until the inner front surface of the
side panel bottoms out against the
outer surface of the stove.
against the side of the stove, slide
the panel toward the rear of the
stove. The front of the panel has
two slots, which will catch behind
Phillips head screws mounted on
the side of the stove (one near the
top, one near the bottom) to hold
the front of the panel in place.
secured behind the two Phillips
head screws, push the back lip of
the panel around the back of the
stove.
to the stove using two screws
mounted through either holes or
slots on the back of the side panel.