3. Align the feed slot cover. Assembly the edge's two latching tabs with
the mounting holes on the scanner. Push the cover back in until it
clicks in place.
Step 3: Using the calibration paper
1. Insert the calibration paper with the white side DOWN into the feed
slot.
2. Press MENU
(
MENU
3. Press LEFT
/RIGHT
( )
press UP
/DOWN
( )
4. Select OK
to begin the calibration process.
)
OK
Note: The process will take few minutes to fi nish, and then shut down
automatically. Please turn the power back on again.
)
button to bring up the System Menu.
button to select Setup (
( )
button to select "Calibration".
( )
) button then
15