Cleaning And Calibrating The Scanner - GiiNii Full Size User Manual

CLEANING AND CALIBRATING
THE SCANNER
• To get high image quality and good recognition results, please
perform step 1, 2, 3 in that order prior to use if necessary.
• Make sure the cleaning and calibration paper, and cleaning stick are
clean without any dust before use.
• Do not use any solvent to clean the sensor.
Step 1: Using the cleaning paper
Insert the supplied cleaning paper into the feed slot of the scanner,
then press SCAN
(
SCAN
Front side
Cleaning paper
Step 2: Using the cleaning stick
1. Put your thumbs in the feed slot and pull the feed slot cover upwards
to remove it from the scanner.
2. Insert the thin end of the cleaning stick into the slot of the scanner at
the rear side. Move the stick from one side to the other slightly a few
times, then remove it.
Rear side
Note: Do not insert the cleaning stick into the feed slot at the front side
of the scanner as this may damage the internal component.
14
button to rolled through and scanned.
)
Cleanning stick