Adding Channels To The Tv's Memory - Toshiba 51H83 Service Manual

ADDING CHANNELS TO THE TV'S MEMORY

When you press Channel 8 or 9, your TV will stop only on the channels stored in the TV 's channel memory.
Follow the steps below to program all active channels into the TV 's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in its memory.After the channels are stored
automatically, you can manually add or erase individual chan-
nels.
To program channels automatically:
1
Press MENU, and then press ; or : until the SET UP
menu appears.
2
Press 8 or 9 until the TV/CABLE is highlighted.
3
Press ; or : to highlight either TV or CABLE, depending
on which you use. If you use an antenna, highlight TV; if
you use cable, highlight CABLE.
4
Press 9 to select CH PROGRAM.
5
Press ; or : to start channel programming.The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected),and store all active
channels in the channel memory.
While the TV is cycling through the channels,the message
"Programming Now —Please Wait " appears.
6
When channel programming is complete,the message
"Completed " appears.
7
Press Channel 8 or 9 to view the programmed channels.
Adding and erasing channels manually
After you have programmed the channels automatically, you
can manually add or erase specific channels.
To add or erase channels:
1
Select the channel you want to add or erase.If you are
adding a channel,you must select the channel using the
Channel Number buttons.
2
Press MENU,and then press ; or : until the SET UP menu
appears.
3
Press 8 or 9 to highlight ADD/ERASE.
4
Press ; or : to select ADD or ERASE, depending on the
function you want to perform.
5
Repeat steps 1-4 for other channels you want to add or
erase.
Note:
To tune TV to a channel not pargrammed in the channel
memory, you must use the Channel Number buttons on the
remote control.
* Please refer to owner's manual in detail.
– 21 –