Husqvarna 334T Workshop Manual page 38

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Assembly 334T, 338XPT (continued)
WARNING!
The fuel used in the chain saw has the follow-
ing hazardous properties:
• The fluid and its vapour are poisonous.
• Can cause skin irritation.
• Is highly inflammable.
Once the carburettor has been pressure tested assembly
continues as follows:
1. Insert the carburettor a little and fit the throttle (X). Now
insert the carburettor fully.
2. Fit the fuel pipe (V) using pliers with smooth jaws. Take
care not to damage the pipe.
3. Fit the choke lever (Y) using pliers.
4. Fit the air filter holder (U), the two bolts and the air filter (S).
Tighten the bolts to1.5 Nm.
5. Fit the carburettor cover.
6. Assemble the chain and bar. See the Operator Guide.
7. The operation of the carburettor is also affected if the intake
manifold and the impulse hose are defective. These parts
should also be checked.
8. To change the manifold pipe, see the chapter "AV-system".
9. To change the pulse tube, see the chapter "Tank unit".
Basic adjustment of the high and low speed
needles
Important! The following must be done before any adjust-
ments are made!
• Fit a bar and chain combination approved for this model. "See
the technical data in the Operator's Guide".
• Tension the chain so that there is still around 0.2 tum/5 mm to
the underside of the bar.
• Fit a new air filter.
Done when the chain saw is assembled.
1. Start the engine and adjust the idling speed using the T-
screw until the chain stops.
2. Adjust the H-needle until the engine's max. speed is 13,000
± 200 rpm. Use a screwdriver with a small blade.
3. Let the engine run at 13,000 rpm until it is warm, about 1
minute.
4. Adjust the H-needle until the engine's speed is 13,400 rpm.
Turn the locking cap to its richest position. (Screw anti-
clockwise until it stops.)
5. Carefully knock the locking cap in position using a suitable
punch (5 mm).
6. Adjust the idling speed to 2,800 rpm.
7. Adjust the L-needle until the highest idling speed has been
reached, now screw the L-needle anticlockwise a 1/2 turn.
Use a screwdriver with a small blade.
8. Adjust the locking cap to its richest position. (Screw
anticlockwise until it stops.) Carefully knock the locking cap
in position using a suitable punch (5 mm).
38
– English
CARBURETTOR
www.mymowerparts.com
X
Y
V
U
S
L
H
T