Philips AJ4000B User Manual

Always there to help you
Register your product and get support at
www.philips.com/welcome
AJ4000B
EN User manual
ES
Manual del usuario
FR Mode d'emploi
P&F USA Inc.
a
PO Box 2248
Alpharetta, GA 30023-2248
Phone 1 866 309 0845
Meet Philips at the Internet
http://www.philips.com/welcome
b
All registered and unregistered trademarks are property of their
respective owners.
© 2013 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ4000B_37_UM_V1.0
EN
i
1 Important safety instructions
Read these instructions.
a
Keep these instructions.
b
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation openings. Install in accordance
with the manufacturer's instructions.
j h Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifi ers) that
produce heat.
i Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
Only use attachments/accessories specifi ed by the manufacturer.
j
SLEEP
Unplug this apparatus during lightning storms or when unused
k
for long periods of time.
l Refer all servicing to qualifi ed service personnel. Servicing is
15 30 60 90 120
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
OFF
or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
m Battery usage CAUTION – To prevent battery leakage which
k
may result in bodily injury, property damage, or damage to the
unit:
•
Install all batteries correctly, + and - as marked on the unit.
•
Remove batteries when the unit is not used for a long time.
Apparatus shall not be exposed to dripping or splashing.
n
o Do not place any sources of danger on the apparatus (e.g. liquid
fi lled objects, lighted candles).
p This product may contain lead and mercury. Disposal of
these materials may be regulated due to environmental
considerations. For disposal or recycling information, please
contact your local authorities or the Electronic Industries
Alliance: www.eiae.org.
q Where the plug of the Direct Plug-in Adapter is used as the
disconnect device, the disconnect device shall remain readily
l operable.
2 Your clock radio
2 2 1 2 2 2
Congratulations on your purchase, and welcome to Philips! To fully
benefi t from the support that Philips offers, register your product at
www.philips.com/welcome.
What's in the box (Fig.
Check and identify the contents of your package.
c
www.philips.com/w elcome
AJ4000
User Manual
3 Get started
Always follow the instructions in this chapter in sequence.
Install battery (Fig. )
Caution
•
Risk of explosion! Keep the battery away from heat, sunshine or fi re. Never
discard battery in fi re.
•
The battery contains chemical substances, so it should be disposed of
properly.
Insert one 9V 6F22 battery (not supplied) with correct polarity (+/-)
as illustrated.
Note
•
The battery can only back up clock and alarm settings.
Connect power (Fig. )
Caution
•
Risk of product damage! Make sure that the power voltage corresponds to
the voltage printed on the back or underside of the clock radio.
•
Risk of electric shock! When you unplug the power adapter, always pull the
plug from the socket. Never pull the cord.
Note
•
The type plate is located at the bottom of the clock radio.
Set clock (Fig. )
1 Switch the slider to SET TIME .
» The hour and minute digits blink.
2 Press HR and MIN to adjust time.
3 Switch the slider to CLOCK to confi rm the setting.
4 Listen to FM radio
Note
•
Keep the clock radio away from other electronic devices to avoid radio
interference.
•
For better reception, fully extend and adjust the position of the FM antenna.
Tune to FM radio stations (Fig. )
1 Switch the slider to RADIO .
)
2 Rotate TUNING to select a station.
» The indicator shows the radio frequency of the waveband.
3 While listening, rotate VOL to adjust volume.
4 Switch the slider to OFF to turn off the radio.
d e
1 2 1
HR
SET TIME
RADIO
3 3 4 2 3
MIN
MIN
CLOCK
5 Set alarm timer
Option 1 :USB socket (Fig.
Note
Set alarm (Fig. )
•
The USB cable is not supplied.
Follow the illustration to set the alarm. •
Some USB cables may not work with this device due to different materials
•
AL1 : Set the fi rst alarm.
and product techniques.
•
AL2 : Set the second alarm.
Select alarm source (Fig. )
Option 2 : Micro USB (Fig.
To select the last heard channel or buzzer as the alarm sound:
•
AL1 : Switch the slider to RADIO or BUZ .
7 Product information
•
AL2 : Switch the slider to RADIO or BUZ .
» The corresponding alarm icon lights up.
Note
Note
•
Product information is subject to change without prior notice.
•
The gentle wake-up function is available for buzzer only.
General information
Deactivate the alarm timer
AC power (power adapter)
Switch AL1 or AL2 to OFF to deactivate the alarm clock.
» If the alarm timer is deactivated, the alarm indicator turns off.
Snooze the alarm (Fig. ) Battery power
Operation Power Consumption
1 When alarm sounds, press SNOOZE .
Standby Power Consumption
» The alarm snoozes and repeats ringing nine minutes later.
USB Charge voltage
2 To reset the alarm, press ALARM RESET .
Micro USB Charge voltage
» The alarm repeats ringing for the next day.
Dimensions - Main Unit
6 Other features (W x H x D)
Weight - Main Unit
Adjust brightness (Fig. )
Tuner (FM)
Tuning Range
Set sleep timer (Fig. )
Sensitivity
- Mono, 26dB S/N Ratio
1 Press SLEEP repeatedly to set the sleep time.
Total Harmonic Distortion
» The radio turns on automatically.
Signal to Noise Ratio
2 To check the remaining sleep time, press SLEEP again.
To deactivate the sleep timer:
• Amplifi er
Press SLEEP repeatedly until [OFF] appears.
Charge your mobile phone
Rated Output Power
You can use this device to charge your mobile phone.
8 Troubleshooting
Note
Warning
•
Make sure that the USB socket and the Micro USB are used only for
charging.
•
•
The USB charging and Micro USB charging are available when AC power is Never remove the casing of this apparatus.
connected.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
f
2 2 1 2 2 1
2
SET AL 2
SET AL 1
2 2 2 2 2 2
TUNING
2 4
HR
HR
3 3 3 3
VOL
OFF
MIN MIN
unsolved, go to the Philips web site (www.philips.com/support). When
)
you contact Philips, ensure that the apparatus is nearby and the model
number and serial number are available.
No power
• Ensure that the AC power plug of the unit is connected properly.
• Ensure that there is power at the AC outlet.
No sound
• Adjust the volume.
No response from the unit
• Disconnect and reconnect the AC power plug, then turn on the unit
again.
)
No charging
• Use the USB cable bypacked with your device for charging.
Poor radio reception
• Increase the distance between the unit and your TV or VCR.
• Fully extend the FM antenna.
Alarm does not work
• Set the clock/alarm correctly.
Clock/alarm setting erased
• Power has been interrupted or the power plug has been
disconnected.
• Back up battery is used up.
• Reset the clock/alarm.
Brand name: Philips
9 Notice
Model: AS100-065-AA130
Input: 100-240 V~ 50/60 Hz, 0.5 A
Output: 6.5 V 1.3 A
Any changes or modifi cations made to this device that are not expressly
9 V
approved by Philips Consumer Lifestyle may void the user's authority to
11 W
operate the equipment.
< 1 W
Compliance
DC 5 V
DC 5 V
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS
173 x 64 x 159 mm standard(s).
The device complies with the FCC-Rules, Part-15. Operation is subject
0.5 kg
to the following two conditions:
•
This device may not cause harmful interference, and
•
This device must accept any interference received, including
interference that may cause undesired operation.
87.5 - 108MHz
Disposal of your old product and batteries
<22 dBf
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.
<3%
Never dispose of your product with other household waste. Please
>45dB
inform yourself about the local rules on the separate collection of
electrical and electronic products and batteries. The correct disposal of
these products helps prevent potentially negative consequences on the
environment and human health.
Your product contains batteries, which cannot be disposed of with
normal household waste.
300mW RMS
Please inform yourself about the local rules on separate collection of
batteries. The correct disposal of batteries helps prevent potentially
negative consequences on the environment and human health.
Please visit www.recycle.philips.com for additional information on a
recycling center in your area.
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
g
AL 1
RADIO
AL 2
BUZ
h
2 2 1 2 2 2
ALARM
RESET
SNOOZE
Copyright
2013 © Koninklijke Philips Electronics N.V.
Specifi cations are subject to change without notice. Trademarks are
the property of Koninklijke Philips Electronics N.V or their respective
owners. Philips reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.
ES
1 Instrucciones de seguridad
importantes
a Lea estas instrucciones.
b Conserve estas instrucciones.
Preste atención a todas las advertencias.
c
Siga todas las instrucciones.
d
No utilice este aparato cerca del agua.
e
Utilice únicamente un paño seco para la limpieza.
f
No bloquee las aperturas de ventilación. Realice la instalación
g
de acuerdo con las indicaciones del fabricante.
h No realice la instalación cerca de fuentes de calor como
radiadores, rejillas de calefacción, estufas u otros equipos que
produzcan calor (incluso amplifi cadores).
Proteja el cable de alimentación. Evite pisar o doblar el cable, en
i
particular a la altura del conector y las terminales de contacto
del aparato.
j Utilice sólo los accesorios que especifi ca el fabricante.
k Desenchufe el equipo durante tormentas eléctricas o cuando
no lo utilice por un período prolongado.
Todos los trabajos de servicio técnico deben ser realizados
l
por personal de servicio califi cado. Solicite el servicio de
asistencia técnica cuando, por ejemplo, el cable de alimentación
o el conector están dañados, si se derramó líquido o cayeron
objetos dentro del aparato, si el equipo estuvo expuesto a la
lluvia o humedad, si no funciona normalmente o si se cayó.
m PRECAUCIÓN. Para evitar que las pilas se sulfaten y provoquen
lesiones y daños materiales o en la unidad:
•
Instale todas las pilas de forma correcta, de acuerdo con los
signos + y - marcados en la unidad.
•
Extraiga las pilas cuando no utilice la unidad durante un
período prolongado.
n No exponga el equipo a goteos ni salpicaduras.
o No coloque objetos sobre el equipo que puedan dañar el
sistema (como por ejemplo, objetos que contengan líquidos o
velas encendidas).
Este producto puede contener plomo y mercurio. La
p
eliminación de estos materiales puede estar sometida a
regulaciones debido a consideraciones ambientales. Para
obtener información sobre el desecho o reciclaje de estos
materiales, comuníquese con las autoridades locales o visite el
sitio de Electronic Industries Alliance: www.eiae.org.
q Si el enchufe del adaptador de la conexión directa de la toma
de corriente funciona como dispositivo de desconexión, debe
estar siempre en un lugar accesible.