Contents
Language
Set the language for display on the menu.
English (Default) / Deutsch / Français / Italiano / Nederlands / Español
/ Svenska /
/ Polski
Auto Standby
When this unit is in the stop state and there is no input signal and operation
for 15 minutes, it automatically enters the standby mode.
For the input source "Analog In" and "Direct iPod" only, when no
operation is performed for eight hours, this unit automatically enters the
standby mode.
On (Default) : The unit goes into standby after 15 minutes.
Off : The unit does not go into standby automatically.
Front panel
Rear panel
Connections
Playback
Settings
Firmware
Set whether or not to check for firmware update, update the firmware,
and display update, upgrade and alert notifications.
2 Update
Update the firmware of Marantz Network Receiver.
Check for Update : Check for firmware updates. You can also check
approximately how long it will take to complete
an update.
Update Start : Execute the update process.
%
• If updating fails, the set automatically retries, but if updating is still not
possible, one of the messages shown below is displayed. If the display reads
as shown below, check the settings and network environment, then update
again.
68
Remote
Tips
Appendix
Index