Asus TX97-XE User Manual page 46

Pentium atx motherboard
Hide thumbs Also See for TX97-XE:
Table of Contents

Advertisement

IV. BIOS SOFTWARE
Delayed Transaction (Disabled)
If Enabled, this frees the PCI Bus during CPU accessing of 8-bit ISA cards which
normally consume about 50-60 PCI Clocks without PCI delayed transaction. If PCI
Bus Masters cannot use the PCI Bus, leave this on the default setting of Disabled for
some ISA cards that are not PCI 2.1 compliant.
16-bit I/O Recovery Time (1 BUSCLK)
Timing for 16-bit ISA cards
8-bit I/O Recovery Time (1 BUSCLK)
Timing for 8-bit ISA cards
Video BIOS Cacheable (Enabled)
Allows the Video BIOS to be cached to allow faster execution. Leave on default
setting of Enabled for better performance, otherwise Disabled.
Memory Hole at Address (None)
This features reserves either 14MB-16MB or 15MB-16MB memory address space to
ISA expansion cards that specifically require this setting. Memory from 14MB and up
or 15MB and up will be unavailable to the system because expansion cards can only
access memory up to 16MB.
....................................................................................................................................
Onboard FDC Controller (Enabled)
When enabled, this field allows you to connect your floppy disk drives to the on-
board floppy drive connector instead of a separate controller card. If you want to
use a different controller card to connect the floppy drives, set this field to Disabled.
Onboard FDC Swap A & B (No Swap)
This field reverses the drive letter assignments of your floppy disk drives. Two
options are available: No Swap and Swap AB. If you want to switch drive letter
assignments, set this field to Swap AB, and the swap will be controlled in hardware.
This works separately from the BIOS Features floppy disk swap feature. It is func-
tionally the same as physically interchanging the connectors of the floppy disk drives.
Onboard Serial Port 1 (3F8H/IRQ4)
Settings are 3F8H/IRQ4, 2F8H/IRQ3, 3E8H/IRQ4, 2E8H/IRQ10, and Disabled for
the onboard serial connector.
Onboard Serial Port 2 (2F8H/IRQ3)
Settings are 3F8H/IRQ4, 2F8H/IRQ3, 3E8H/IRQ4, 2E8H/IRQ10, and Disabled for
the onboard serial connector.
46
ASUS TX97-XE User's Manual

Advertisement

Table of Contents
loading

Table of Contents