Table of Contents
Advertisement
icon and entering the settings. Once done, the PTZ's presets, pattern or cruise settings
must be created. This is done by calling up the PTZ Control through the Short-cut Menu.
k. DELAY - Once the alarm stops the recording will continue for a set period of 10 to 300
seconds then stop.
l.
SHOW MESSAGE – If the checkbox is highlighted an Alarm Status screen will appear on
the monitor when a video blind event occurs.
m. BUZZER – If the checkbox is highlighted a beep will be heard when a video blind event
occurs.
n. SEND EMAIL – If the checkbox is highlighted an email will be automatically sent to a
designated individual when a video blind event occurs. Go to Main Menu, click the
System icon and then click the NetService icon to enter the desired email setting.
o. After all selections are made click OK.
Auto Recording – Video Loss
When there is a video loss situation (such as a camera cable being cut) it is possible to create an
alarm and display a video loss message on the security monitor. The process of setting up auto
recording for video loss is similar to Motion Detection and Video Blind.
a. Go to Main Menu, click the Alarm icon and then click the Video Loss icon. . A Video
Loss setup screen similar to the one below will appear.
a. CHANNEL – Select the camera from the drop-down menu.
b. ENABLE – Highlight the checkbox if the Video Loss function is to be enabled.
c. SENSITIVITY – Select from the six levels of motion sensitivity from the drop-down menu.
d. PERIOD – To set the day and time period for the video loss to take place click SET and a
Set Screen appears. Select the desired day from the drop-down menu or ALL for the
entire week. Four possible time slots are available for each day. Use the mouse and soft
keyboard to enter the required time periods. Upon doing so the graphic will adjust to
indicate the selected days and time periods. When done, click OK.
e. ALARM OUTPUT – There is no alarm function with this model DVR.
v2.0 11/8/11
23
Advertisement
Table of Contents
