Saeco Intuita HD8750 User Manual page 45

Machine actions
Coff ee does not have enough
crema.
(See note)
The machine takes a long
time to warm up or the
amount of water dispensed
from the wand is too little.
The brew group cannot be
removed.
There is a lot of ground coff ee
under the brew group.
The machine grinds the
coff ee beans but no coff ee
comes out.
(See note)
Coff ee is too weak.
(See note)
Coff ee is brewed slowly.
(See note)
Coff ee leaks out of the di-
spensing spout.
Causes
The blend is unsuitable, coff ee is
not freshly roasted or the grind is
too coarse.
The machine circuit is clogged by
limescale.
The brew group is out of place.
The coff ee grounds drawer is
inserted.
Coff ee is not suitable for automa-
tic machines.
There is no water.
The brew group is dirty.
The circuit is not primed.
This might occur when the machi-
ne is automatically adjusting the
dose.
The dispensing spout is dirty.
This might occur when the machi-
ne is automatically adjusting the
dose.
The coff ee grind is too fi ne.
The circuit is not primed.
The brew group is dirty.
The dispensing spout is clogged.
Note:
These problems can be considered normal if the coff ee blend has been
changed or if the machine has just been installed. In this case wait until
the machine performs a self-adjusting operation as described in chapter
"Saeco Adapting System".
ENGLISH
Solutions
Change coff ee blend or adjust the
grinder settings as explained in sec-
tion "Adjusting the Coff ee Grinder".
Descale the machine.
Turn the machine on. Close the ser-
vice door. The brew group automati-
cally returns to the initial position.
Remove the coff ee grounds drawer
before removing the brew group.
It may be necessary to change the
type of coff ee or the coff ee grinder
settings.
Fill the water tank and prime the
circuit (chapter "Using the machine
for the fi rst time").
Clean the brew group ("Weekly clea-
ning of the brew group" chapter).
Prime the circuit (chapter "Using the
machine for the fi rst time").
Brew a few cups of coff ee as de-
scribed in chapter "Saeco Adapting
System".
Clean the dispensing spout.
Brew a few cups of coff ee as de-
scribed in chapter "Saeco Adapting
System".
Change coff ee blend or adjust the
grind as explained in chapter "Adju-
sting the ceramic coff ee grinder".
Prime the circuit (chapter "Using the
machine for the fi rst time").
Clean the brew group ("Weekly clea-
ning of the brew group" chapter).
Clean the dispensing spout and its
holes.
43