Table of Contents
Advertisement
PRESET FOR USE
• The cable converter box must be turned on if your TV/VCR is connected
directly to it. (See NOTES:)
• You must use the remote control for the following steps.
NOTES:
• Auto clock setting only has to be done one time. You may set the clock only if
the clock's time has become incorrect for some reason.
• If the TV/VCR is connected directly to a cable converter box, the local PBS
station must be selected on the cable box itself, and the TV/VCR must be set to
the output channel of the cable converter box (usually channel 3 or 4), to be able
to set up or correct the clock automatically.
The TV/VCR cannot control the channels of the cable converter box.
1 Select "SETTING CLOCK"
Press MENU button repeatedly to point to "SETTING CLOCK".
Then, press SELECT button.
2 Set "AUTO CLOCK" to [ON]
Press CH
3 Enter the channel number for the PBS station
Press MENU button.
Then press CH
local PBS station appears.
If you do not know the PBS channel number, remain on [AUTO]. The
TV/VCR will automatically search all available channels for the local PBS
station, and will select that channel.
4 Exit the Auto Clock Setting
Press MENU button repeatedly until the TV/VCR returns to the TV mode.
5 Turn off the TV/VCR
Press POWER button to turn off the TV/VCR for searching the local PBS
station. The power must remain off during this search.
If you enter the channel number manually,
• It may take a few minutes for this search to be completed.
If you choose [AUTO],
• The TV/VCR must search through all the available channels one by one,
starting with the lowest numbered channel. It must scan each channel of
minutes to determine if that channel is transmitting the XDS signal, because
the PBS station will send this signal only once every minute. This search
or
button repeatedly until [ON] appears.
or
button repeatedly until the channel number for your
23
Advertisement
Table of Contents
