Table of Contents
Advertisement
RS-232C Communication
RS-232C Communication
Connecting The Cable
Turn off the projector and the computer power supplies.
1
Connect the CONTROL port of the projector with a RS-232C port of the computer by
2
a RS-232C cable. Use the cable that fulfills the specification shown in the previous
page.
Turn on the computer power supply and after the computer has started up, turn on
3
the projector power supply.
Communications Setting
19200bps, 8N1
1. Protocol
Consist of header (7 bytes) + command data (6 bytes).
2. Header
BE + EF + 03 + 06 + 00 + CRC_low + CRC_high
CRC_low : Lower byte of CRC flag for command data
CRC_high : Upper byte of CRC flag for command data
3. Command data
Command Data Chart
byte_0
byte_1
Action
low
high
Action (byte_0 - 1)
Action
1
SET
2
GET
4
INCREMENT
5
DECREMENT
6
EXECUTE
byte_2
byte_3
Type
low
high
Classification
byte_4
byte_5
Setting code
low
high
Change setting to desired value.
Read projector internal setup value.
Increment setup value by 1.
Decrement setup value by 1.
Run a command.
Content
7
Advertisement
Table of Contents
