Setting Up The Base Transmitter - Sunbeam in-ground fencing system Instruction Manual

settInG UP tHe base tRansMItteR

IMPORTANT: The Base Transmitter should be placed in a dry, well ventilated area indoors. Do not place the Base
Transmitter in an area where temperatures fall below freezing (fig. 1). Do not place the Base Transmitter within 3
feet of any appliances or large metal objects (fig. 2). AC adaptor is for indoor use only.
figure 1
The Base Transmitter creates the signal that goes to the Boundary Wire to create the Boundary Zone. From the
Base Transmitter you control the Boundary Zone Area (the distance from the wire where the warning signal
and correction begins). The Boundary Wire must run from the Base Transmitter to outside. It is recommended
you mount the Base Transmitter to the inside of an exterior wall so you can easily run the Boundary Wire
outside. Remember, the Boundary Wire must begin at the Base Transmitter and make a continuous loop back
to the Base Transmitter .
On the back of the Base Transmitter there is a Yard Switch (fig. 3). The default setting is Hi. Use this setting to test
the system before you mount the Base Transmitter to the wall. If the Boundary Zone is too big, adjust the Yard
Switch to Low .
figure 3
10
figure 2