Coleman 2000004407 Setup Instructions

Before you begin

Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your shelter.
WARNING: Keep clear of overhead power lines.
• Do not set up your shelter under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property
damage or personal injury.
• For best results in windy conditions, position narrow end of
shelter into the wind.
• Do not drop shelter.
• Do not bounce shelter bag on its end to remove shelter, as these
actions may damage the frame.
• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
• Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the
shelter frame.

Repair Parts List

Description
Shelter top
1

Extend the Shelter Frame

• With two persons standing at diagonal corners of the structure,
grab the leg, and pull out to unfold frame. (Fig. 1)
NOTE: Do not unfold frame completely. This will allow easier fit
for draping shelter top over frame.
Extend Lower
Roof Pole
Fig. 1
2

Set up the Shelter

• Drape the upper and lower roof top over frame. (Fig. 2)
• Insert the roof poles into shelter pockets (found at the shelter
corners). (Fig. 2A)
Lower Roof
Fig. 2
SHELTER SETUP INSTRUCTIONS
Part Number
5010000764
Upper Roof
Roof Pole
Fig. 2A
Shelter
Pocket
MODEL 2000004407
• Pull up sliding bracket located
on upper portion of leg until push
button snaps into place (Fig. 3).
This will ensure top of frame is
fully extended.
HANDY TIP: To fully engage the
push button, grip the top and bottom
frame members and squeeze as
shown in Fig. 3A. Be careful to avoid
pinch points.
• Secure shelter top to frame with hook & loop fasteners provided.
(Fig. 4 & 5)
Fig. 4
3

Adjust the Height

• Adjust desired height until push button locks into place, making
sure all four posts are level. (Fig. 6 & 7)
Push
Button
Fig. 6
4

Stake the Shelter

• Secure shelter by driving stakes through the holes in the base
of each frame post. (Fig. 8)
Fig. 8
Push Button
Fig. 3
Fig. 3A Fig. 3A
Fig. 5 Fig. 5
Upper
Portion
of Leg
Push
Button
Fig. 7
(continued on other side)