Coleman 2000004413 Setup Instructions

Before you begin
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your shelter.
WARNING: Keep clear of overhead power lines.
• Do not set up your shelter under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property
damage or personal injury.
• For best results in windy conditions, position narrow end of
shelter into the wind.
• Do not drop shelter.
• Do not bounce shelter bag on its end to remove shelter, as these
actions may damage the frame.
• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
• Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the
shelter frame.
Replacement Parts List
Description
Shelter Top
1
Extend the Shelter Frame
• With two persons standing at diagonal corners of the structure,
grab the leg, and pull out to unfold frame. (Fig. 1)
NOTE: Do not unfold frame completely. This will allow easier fit
for draping shelter top over frame.
Fig. 1
2
Set up the Shelter
• Drape shelter top over frame. (Fig. 2)
• Attach nylon fasteners, located on corners of shelter top, to six
corners of frame post. (Fig. 2A)
Fig. 2
SHELTER SETUP INSTRUCTIONS
MODEL 2000004413
Part Number
5010000766
2A 2A
• Pull up sliding bracket located on upper
portion of leg until push button snaps into
place. (Fig. 3) This will ensure upper portion
of frame is fully extended.
HANDY TIP: To fully engage the
push button, grip the top and bottom
frame members and squeeze as
shown in Fig. 3A. Be careful to avoid
pinch points.
• Secure shelter top to frame with nylon fasteners provided. (Fig. 4 & 5)
Fig. 4
3
Adjust the Height
• Adjust desired height until push button locks into place, making
sure all four posts are level. (Fig. 6 & 7)
Push
Button
Fig. 6
4
Install the Screen
• Unroll screen house and wrap around outside frame posts and
under the shelter top. Locate zippers per illustrations. (Fig. 8)
• Attach top of screen to frame with hooks and loops
provided. (Fig. 9 & 10)
NOTE: Shelter should be set at the highest
position when used with screen house.
Fig. 8
Zippers
Push
Button
Fig. 3
Fig. 3A Fig. 3A
Fig. 5 Fig. 5
Upper
Portion
of Leg
Push
Button
Fig. 7
Fig. 9 Fig. 9
Fig. 10 Fig. 10
(continued on other side)