Uncle Milton Wallscape FX Activator Instruction Manual

SCENE SET-UP
1
Install the Wallscape FX Activator
Before installing your Activator, move the function sw itch on the
back of the Activator from "Try Me" to "Play". This will enable full
special e ects functionality.
The Activator should only be mounted on a vertical surface. For
optimal results, place a nail or screw into the wall approximately
4 feet from the oor. Then, position the Activator onto the wall by
placing the hang hole on the back of activator directly over the nail
until securely in place.
Note: For rooms with ceilings higher than 8 feet, you may want to
position the activator higher than 4 feet to ensure that the light
su ciently illuminates the wall and the ceiling.
2
Wall Decal Preparation
After removing the decals from the package, roll out the sheet and lay
at for 24 – 48 hours until the sheet no longer wants to curl back up.
For best results apply the decals onto smooth, clean surfaces. The decals
may not stick to heavily textured surfaces. Do not apply to fresh paint or
wallpaper. Let the new paint/wallpaper dry for at least 3 weeks. Before
applying the decals to wallpaper or other delicate surfaces, test one in an
inconspicuous area. Keep the decals away from cribs and out of reach of
young children to prevent choking hazard.
3
Create your Scene by placing the Wall Decals
To apply each decal, carefully peel it o from the sheet. Then, place and
smooth the decal onto your wall in the desired location. To remove or
reposition each decal, just carefully peel it o from the wall. Kids can follow the
suggested scene layout or customize and create their own scene. For optimal
function with the light e ects, please note the following suggestions on wall decal
placement:
• Begin with Ariel's tail positioned 6 inches above the top of the Activator.
• Place all other decals around the Ariel decal but ideally no more than 36 inches
above the top of the Activator. This will help to ensure that all decals are
illuminated by the light cast.
4
On textured walls, periodically check the decals to make sure they are remaining at
against the surface. Gently smooth any parts of the decal, that appear to be lifting o the
surface. Repeat as needed until the decals remain at against the surface.

INSTRUCTION MANUAL

on your Wall
TM
DO NOT SKIP THIS STEP
Wallscape FX Activator Wallscape FX Activator
Battery
Cover
Scene Set-Up Scene Set-Up
36 inches
TM TM
Hang
Hole
TRY ME
Function
Switch
PLAY
PRODUCT STYLES
MAY VARY
6 inches
Top of Wallscape
FX Activator
4 Feet
Floor
5+
2232