Table of Contents
Advertisement
Operation
Battery Charging & Recharging
1. Connect the Charging Adaptor to the Charging Jack on the rear of the Main Unit, and then plug into
an electrical outlet. The LED illuminates RED when the charger is connected.
2. Charge the unit for at least 16 hours. Do not charge the sweeper for longer than 24 hours.
3. Once the battery is fully charged switch o the charger at the mains socket, remove the charging jack from
the battery pack, and unplug the charger from the mains socket. Do not pull the charger by the cord, grasp
the charger and pull to disconnect.
WARNING: Only use the charger provided with the product. Using another charger may damage the
product and battery.
WARNING: Before use check the power supply and charger cables for signs of damage or ageing.
A damaged charger can increase risk of re or electric shock.
WARNING: If the battery is damaged in any way do not attempt to charge it and replace it immediately.
WARNING: Never run the battery empty and then put the product away without switching it o - deep
discharge can damage the battery.
IMPORTANT: To maintain peak performance of your cordless sweeper, it is recommended that
the unit be fully discharged, then completely recharged at least once a month.
7
The LED does not ash or change colour
when the unit is fully charged. The unit will
only re-charge when the unit is switched o .
Vax Service line:
AU: 1300 361 505
NZ: 0800 800 900
Advertisement
Table of Contents
