Wheel And Tire Combinations; Tires/Wheels; Lowering; Tightening Torque - Mercedes-Benz SLS AMG GT Coupe Operator's Manual

Tighten the wheel bolts until they are
X
finger-tight.
Unscrew the alignment bolt.
X
Tighten the last wheel bolt until it is finger-
X
tight.
Lowering the vehicle
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
Turn the crank of the jack counter-
X
clockwise until the vehicle is once again
standing firmly on the ground.
Place the jack to one side.
X
Tighten the wheel bolts evenly in a
X
crosswise pattern in the sequence
indicated (: to A). The specified
tightening torque is 133 lb-ft(180 Nm).

Wheel and tire combinations

Turn the jack back to the out-of-use
X
position and stow it in the trunk again with
the rest of the wheel-changing tools.
Wheel and tire combinations
General notes
! For safety reasons, Mercedes-Benz
recommends that you only use tires and
wheels which have been approved by
Mercedes-Benz specifically for your
vehicle.
These tires have been specially adapted for
use with the control systems, such as ABS
®
or ESP , and are marked as follows:
MO = Mercedes-Benz Original
R
MOE = Mercedes-Benz Original Extended
R
(tires featuring run-flat characteristics)
MO1 = Mercedes-Benz Original (only
R
certain AMG tires)
Mercedes-Benz Original Extended tires
may only be used on wheels that have been
specifically approved by Mercedes-Benz.
Only use tires, wheels or accessories
tested and approved by Mercedes-Benz.
Certain characteristics, e.g. handling,
vehicle noise emissions or fuel
consumption, may otherwise be adversely
affected. In addition, when driving with a
load, tire dimension variations could cause
the tires to come into contact with the
bodywork and axle components. This could
result in damage to the tires or the vehicle.
Mercedes-Benz accepts no liability for
damage resulting from the use of tires,
wheels or accessories other than those
tested and approved.
Information on tires, wheels and approved
combinations can be obtained from any
qualified specialist workshop.
i
The Tire and Load Information placard
with the recommended tire pressures is on
the B-pillar on the driver's side. Further
information about driving at high speeds or
273
Z