Table of Contents
Advertisement
USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE FUNCTIONS
- 28 -
this occurs, the remote control is programmed for your cable/satellite box. If the cable/satellite box does not turn off after
five seconds, try another two digit preset code.
5. The remote will now control your cable/satellite box.
(1) CABLE Button
This button allows the remote to control your cable/satellite box by setting it to cable.
(2 )PRECODED CABLE/SATELLITE Box Buttons
These buttons transmit the chosen precoded CABLE/SATELLITE codes.
(3) EXCLUSIVE TV Buttons
These buttons are for operating the TV.
NOTES:
1. If your cable/satellite box cannot be operated after performing the above procedures, your cable/satellite box code has
not been precoded into the remote.
2. In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures, please
consult your cable/satellite box operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the remote
control. After replacing the batteries repeat the entire programming procedure stated above.
4. If your cable/satellite box does not have a power function, the remote will issue the CHANNEL UP function.
5. The LST-CH button will act as your audio component's ENTER button if required.
6. The SLEEP button will act as your audio components '100' button if required.
Advertisement
Table of Contents
