Cisco WUSB54AG Quick Installation Manual page 8

Connect the Wireless A/G USB
2
Network Adapter
A
Connect one end of the
included USB cable to the USB
port of the Adapter.
B
Connect the other end to a
USB port on your PC. When the
Adapter is plugged in, the
Power LED should light up.
C
Raise the antenna. It should
point straight up into the air, at
a 90º angle from the Adapter.
D
After the Adapter is installed,
the Wireless Network Monitor
icon will appear in the system
tray at the bottom right-hand
corner of your screen.
Double-click the icon if you
want to check the link
information, search for
available wireless networks, or
make additional configuration
changes.
Congratulations! The installation of
the Wireless A/G USB Network
Adapter is complete.
8
A
D
For additional information or troubleshooting
help, refer to the User Guide on the CD-ROM
or the Technical Support Insert. You can also
e-mail for further support.
Website
http://www.linksys.com/international
Linksys is a registered trademark or trademark of
Cisco Systems, Inc. and/or its affiliates in the U.S.
and certain other countries. Copyright © 2005
Cisco Systems, Inc. All rights reserved.
WUSB54AG-EU-LA-UK-QIG-50110NC JL