BIOS Setup
▶
PCIE GEN3
Ths tem s used to enable (Auto)/ dsable (Dsabled) the PCIe generaton 3
support.
▶
PCI Latency Tmer
Controls how long each PCI devce can hold the bus before another takes over.
When set to hgher values, every PCI devce can conduct transactons for a longer
tme and thus mprove the effectve PCI bandwdth.
▶
ACPI Settngs
Press <Enter> to enter the sub-menu.
▶
ACPI Standby State
Specfies the power savng mode for ACPI functon
[S1]
Sleep Mode. Hardware remans on.
[S3]
Suspend to RAM. Turns off hardware. (Recommended)
▶
Power LED
Configures how the system uses power LEDs on the case to ndcate sleep/
suspend state.
[Sngle]
[Dual]
[Blnkng]
▶
Integrated Perpherals
Press <Enter> to enter the sub-menu.
▶
Onboard LAN Controller
Ths tem allows you to enable/ dsable the onboard LAN controller.
▶
LAN Opton ROM
Ths tem s used to decde whether to nvoke the Boot ROM of the onboard LAN.
▶
Network Stack
Ths tem s used to enable/ dsable UEFI network stack.
▶
Ipv4 PXE Support
Ths tem appears when you set "Enabled" n [Network Stack] field and s used to
enable/ dsable the Ipv4 PXE boot support.
▶
Ipv6 PXE Support
Ths tem appears when you set "Enabled" n [Network Stack] field and s used to
enable/ dsable the Ipv6 PXE boot support.
▶
SATA Mode
Ths tem s used to specfy RAID/ IDE/ AHCI mode for SATA port.
Important
•
Wndows XP s not natvely supported to be nstalled n the storage devce wth AHCI
mode. If you stll prefer to nstall Wndows XP as the operatng system, please refer
to Appendx Install Wndows XP Notes.
•
You cannot swtch between AHCI and IDE f you already have your operatng system
2-6
The power LED turns off durng the sleep/suspend mode.
The power LED changes ts color to ndcate the sleep/suspend
state.
The power LED blnks to ndcate the sleep/suspend state.