▶
HPET
The HPET (Hgh Precson Event Tmers) s a component that s part of the chpset.
You can enable t, and wll provde you wth the means to get to t va the varous
ACPI methods.
▶
USB Configuraton
Press <Enter> to enter the sub-menu.
▶
USB Controller
Ths tem allows you to enable/ dsable the ntegrated USB 2.0 controller.
▶
Legacy USB Support
Enable or dsable support for USB keyboards, mce and floppy drves. You wll be
able to use these devces wth operatng systems that do not support USB.
▶
Onboard USB 3.0 Controller
Ths tem allows you to enable/ dsable the USB 3.0 controller.
▶
Super IO Configuraton
Press <Enter> to enter the sub-menu.
▶
Seral(COM) Port 0 Configuraton
Press <Enter> to enter the sub-menu.
▶
Seral (COM) Port0
Ths tem allows you to enable/ dsable the seral port.
▶
Seral (COM) Port0 Settngs
Select an address and correspondng nterrupt for the seral port.
▶
Hardware Montor
Press <Enter> to enter the sub-menu.
▶
CPU Smart Fan Target
Controls CPU fan speed automatcally dependng on the current temperature and
to keep t wth a specfic range. If the current CPU temperature reaches the target
value, the smart fan functon wll be actvated.
▶
Power Management Setup
Press <Enter> to enter the sub-menu.
▶
EuP 2013
Energy Usng Products Lot 6 2013 (EUP) reduces power consumpton when system
s off or n standby mode.
Note: When enabled, the system wll not support RTC wake up event functons.
▶
Restore after AC Power Loss
Ths tem specfies whether your system wll reboot after a power falure or nterrupt
occurs. Settngs are:
[Power Off]
Always leaves the computer n the power off state.
[Power On]
Always leaves the computer n the power on state.
[Last State]
Restore the system to the status before power falure or nterrupt
occurred.
MS-7760
MS-7760
2-7