MSI B75A-G43 seres User Manual page 52

BIOS Setup
read command starts.
▶ tRRD
Specfies the actve-to-actve delay of dfferent banks.
▶ tRTP
Tme nterval between a read and a precharge command.
▶ tFAW
Ths tem s used to set the tFAW (four actvate wndow delay) tmng.
▶ tWCL
Ths tem s used to set the tWCL (Wrte CAS Latency) tmng.
▶ Advanced Channel 1/ 2 Tmng Configuraton
Press <Enter> to enter the sub-menu. And you can set the advanced memory tmng
for each channel.
▶ GT OverClockng
Ths tem allows you to enable/ dsable the overclockng of ntegrated graphcs.
▶ GT Rato
Ths settng controls the rato of ntegrated graphcs frequency to enable the ntegrated
graphcs to run at dfferent frequency combnatons.
▶ Adjusted GT Frequency
It shows the GPU frequency. Read-only.
▶ Spread Spectrum
Ths functon reduces the EMI (Electromagnetc Interference) generated by modulatng
clock generator pulses.
Important
• If you do not have any EMI problem, leave the settng at [Dsabled] for optmal system
stablty and performance. But f you are plagued by EMI, select the value of Spread
Spectrum for EMI reducton.
• The greater the Spread Spectrum value s, the greater the EMI s reduced, and the
system wll become less stable. For the most sutable Spread Spectrum value, please
consult your local EMI regulaton.
Remember to dsable Spread Spectrum f you are overclockng because even a slght
•
jtter can ntroduce a temporary boost n clock speed whch may just cause your
overclocked processor to lock up.
▶ CPU Core Voltage/ DRAM Voltage.
These tems are used to adjust the voltage of CPU and Memory.
▶ Current CPU Core Voltage/ Current DRAM Voltage
These tems show current CPU/ DRAM voltage. Read-only.
2-12