Figure 4-7: Wireless Settings - Linksys WPS54GU2 User Manual

Wireless-G PrintServer for USB 2.0
8. The Wireless Settings screen will appear. In the SSID field, enter your wireless network's SSID or name. This
is the unique name shared by all devices in a wireless network. The SSID is case-sensitive and should have
32 characters or fewer.
IMPORTANT: It is important that you read and observe the domain setup instructions below.
Users must select the correct domain during the setup and obtain any permit or authorization to
operate this product as required by the governing laws of that country. Linksys disclaims any
liability whatsoever as permitted by law if the following domain setup is not observed. This
device is not meant for outdoor use.
Select the continent you're located in for the domain (Africa, Asia, Australia, Europe, or South America) from
the drop-down menu. If you're located in France, Israel, Japan, or Mexico, select your country from the list.
If your network is set to ad-hoc mode, select the channel at which the network broadcasts its wireless signal.
The Network Type setting shows a choice of two wireless modes. Select Infrastructure if you want the
PrintServer to communicate using an access point or wireless router. Select Ad-Hoc if you want the
PrintServer to communicate without using an access point or wireless router.
Click the Next button to continue.
Chapter 4: Configuring the PrintServer Using the Setup Wizard
Installation

Figure 4-7: Wireless Settings

SSID: your wireless network's name.
Infrastructure: configuration in which a
wireless network is bridged to a wired network
via an access point.
Ad-hoc: a group of wireless devices
communicating directly to each other (peer-to-
peer) without the use of an access point.
9