Specifications; Preamplifier Section - NAD C 356BEE Owner's Manual

PREAMPLIFIER SECTION

LINE LEVEL INPUT, PRE OUT
THD 1 20 Hz – 20 kHz, CCIF IMD, SMPTE IMD, DIM 100
TONE CONTROLS
POWER AMPLIFER SECTION
MAIN IN, SPEAKER OUT
Continuous output power into 8 ohms and 4 ohms (Stereo)
Rated THD 1 20 Hz – 20 kHz, CCIF IMD, SMPTE IMD, DIM 100
TRIGGER OUT
Signal-to-Noise Ratio
Channel separation -1 kHz
10 kHz
Input impedance (R and C)
Maximum input signal
Output impedance - Pre out
Tape out
Input sensitivity
Frequency response
Maximum voltage output -IHF load
600 ohms load
Treble
Bass
Clipping power
IHF dynamic headroom - 8 ohms
4 ohms
IHF dynamic power - 8 ohms
4 ohms
2 ohms
Peak output current
Signal-to-noise ratio
Damping factor
Frequency response
Input impedance
Input sensitivity
Voltage gain
Headphone output impedance
Channel separation - 1 kHz
10 kHz
Output resistance
Output current
Output voltage
<0.005 % at 2 V out
>106 dB (IHF; A-weighted, ref. 500 mV out, unity gain)
>114 dB (A-weighted, ref. 2 V out, Volume maximum)
>92 dB (ref. 100 mV out, unity gain)
>80 dB
>68 dB
22 kohms+ 100 pF
>6 Vrms (ref. 0.1 % THD)
80 ohms
Source Z + 1 kohm
166 mV (ref. 500 mV out)
±0.3 dB (20 Hz - 20 kHz, Tone defeat ON)
±0.3 dB (20 Hz - 20 kHz, Tone defeat OFF)
>10 V (ref. 0.03 % THD)
>8 V (ref. 0.03 % THD)
±5 dB at 10 kHz
±8 dB at 100 Hz
>80 W (at rated THD, 20 Hz-20 kHz, both channels driven)
<0.007 %
>90 W (at 1 kHz 0.1 % THD)
+2.6 dB
+4.4 dB
145 W
220 W
290 W
>50 A (in 1 ohm, 1 ms)
>101 dB (A-weighted, ref. 1 W)
>120 dB (A-weighted, ref. 80 W)
>100 (at 8 ohms, 50 Hz and 1 kHz)
±0.3 dB (ref. 20 Hz - 20 kHz)
3 Hz – 70 kHz (ref. -3 dB)
20 kohms + 1 nF
950 mV (for 80 W in 8 ohms)
29 dB
68 ohms
>80 dB
>70 dB
75 ohms
150 mA
+12 V ± 10 %
REFERENCE

SPECIFICATIONS

15