CONDITION
No sound from all channels.
No sound from some channels.
No sound from surround channels.
No sound from Subwoofer.
No sound from Center channel.
No Dolby Digital/DTS.
T 748 does not respond to remote
control commands.
No RDS information.
Display shows "No Service List".
POSSIBLE CAUSES
• AC power unplugged.
• Power not switched on.
• Outlet has no power.
• Mute function is activated.
• Faulty/missing cables.
• "Speaker Configuration" channel (s) set to "OFF".
• No surround listening mode is engaged.
• Surround channels set to "OFF" on "Speaker
Configuration" menu.
• Surround channels level set too low on "Speaker
Levels" menu.
• Subwoofer is off, not powered or improperly
connected.
• Subwoofer set to "OFF" on "Speaker
Configuration" menu.
• Subwoofer level set too low on "'Speaker Levels"
menu.
• Source is a 2/0 (etc.). Dolby Digital or DTS
recording without center channel.
• Center set to "OFF" on "Speaker Configuration"
menu.
• Center level set too low on "Speaker Levels"
menu.
• Source's digital output is not connected to a
T 748 digital input.
• Source component not configured for
multichannel digital output.
• Batteries are flat or incorrectly inserted.
• Infrared receiver (IR) window of T 748 or IR
transmitter of the remote control is obstructed.
• T 748 front panel is in very bright sunlight or
ambient light.
• Station signal too weak.
• Station not transmitting RDS data.
• DAB antenna not connected properly.
• No DAB coverage in the area.
REFERENCE
TROUBLESHOOTING
POSSIBLE SOLUTIONS
• Check AC cable connection and outlet.
• Toggle [MUTE] button to deactivate Mute
function.
• Check cables.
• Check "Speaker Configuration" menu.
• Select appropriate listening mode.
• Correct "Speaker Configuration" or "Speaker
Levels" settings.
• Power up subwoofer, check subwoofer's AC
outlet or check connections.
• Correct "Speaker Configuration" or "Speaker
Levels" settings.
• Play a known 5.1-channel recording or select
Dolby Pro Logic IIx Music mode.
• Correct "Speaker Configuration" or "Speaker
Levels" settings.
• Check connections.
• Check source component setup.
• Check batteries.
• Check IR windows and ensure clear line-of-sight
from remote to T 748.
• Reduce sunlight/room lighting.
• Check station tuning. Adjust or replace antenna.
• Tune to an RDS station that supports program-
service name (PS mode) and radio-text mode
(RT).
• Check the connection and position of DAB
antenna.
• Call your local DAB broadcast providers for
coverage information.
37