Using The Zr 7 Remote Control - NAD T 748 Owner's Manual

RESET THE AVR 4 TO ITS DEFAULT SETTINGS
The AVR 4 can be restored to its factory settings, including default libraries,
via the following procedures
1 Press and hold [ON] and [DELETE] buttons for about 10 seconds until
the AMP device button lights up.
2 Within two seconds of the AMP device button lighting up, release both
buttons. If the reset mode is successful, the [BD] device button will flash
twice.
TABLE OF LIBRARY CODES APPLICABLE TO AVR 4 REMOTE
CONTROL
LIBRARY CODE NAD PRODUCT DESCRIPTION
10 Default library for "AMP" page
11 Zone 2
20 C 515BEE, C 545BEE, C 565BEE
21 T 535, T 585, M55; DVD section of L 54, VISO TWO, VISO FIVE
22 T 513, T 514, T 515, T 517
23 T 587, T 557, T 577, M56
30 IPD 1
31 IPD 2
Default library for "TUN" page; Tuner section of C 725BEE, T 175,
40
T737, T 748, T 755, T 765, T 775, T 748
41 C 422, C 425, C 426
42 C 445
NOTE
The AVR 4 may not necessarily contain all the control buttons applicable
for the above-mentioned NAD products. Use the prescribed remote
control of the specific NAD product for a full compliment of the
applicable remote control buttons.
IDENTIFICATION OF CONTROLS
AVR 4 REMOTE CONTROL

USING THE ZR 7 REMOTE CONTROL

The ZR 7 is a discrete compact remote for controlling the Zone 2 feature of the
T 748. Irrespective of the main room/zone settings, the ZR 7 allows full separate
control of the Zone 2 source selection among other applicable features.
1
2
5
1 ON/OFF: Switch ON/OFF the Zone feature.
2 SOURCE [ d/f ]: Select the active input of the NAD T 748 that will be
sent out to the corresponding rear panel ZONE 2 output port.
3 MUTE: Temporarily switch OFF or restore the Zone Volume level.
4 VOLUME [ d/f ]: Increase or decrease Zone 2 audio output level. This
is applicable only when Zone 2 is the selected setting of "Back Amp" in
the "Amplifier Setup" menu.
5 PRESET [ a/s ]: Step up or down between stored radio presets. This
control button is possible if the selected Zone is "TUNER" and the active
tuner section has stored presets.
6 The following CD Player Zone buttons can control a compatible CD
Player. The CD Player has to be powered ON and disc loaded.
SKIP [ 0 ]: Go to the beginning of a track/file or previous track/file.
SKIP [ 9 ]: Go to the next track/file.
[ 4 ]: Start playback.
3
4
6
13