Hitachi 42V710 Operating Manual page 18

CONNECTING AN S-VIDEO SOURCE TO INPUT 3, 4 AND 5
1. Connect the cable from the S-VIDEO OUT of the VCR or the laserdisc player to the INPUT (S-VIDEO) jack, as shown on the TV
set below.
2. Connect the cable from the AUDIO OUT R of the VCR or the laserdisc player to the INPUT (AUDIO/R) jack.
3. Connect the cable from the AUDIO OUT L of the VCR or the laserdisc player to the INPUT (AUDIO/L) jack.
4. Press the INPUTS button, then select INPUT 3 from the INPUTS menu to view the program from the VCR or laserdisc player.
The VIDEO OSD label disappears automatically after approximately four seconds.
5. Select Antenna from the INPUTS menu to return to the previous channel.
NOTES:
1. Completely insert the connection cord plugs when connecting to rear panel jacks. The picture and sound that is
played back will be abnormal if the connection is loose.
2. A single VCR can be used for VCR #1 and VCR #2 (see page 13), but note that a VCR cannot record its own video
or line output. Refer to your VCR operating guide for more information on line input-output connections.
CONNECTING EXTERNAL VIDEO DEVICES
ANT A
ANT B
INPUT 2 INPUT 1
Y/ Y/
VIDEO VIDEO
MONITOR OUT INPUT 4 INPUT 3
S-VIDEO
P P
B B
P P
R R
VIDEO
(MONO) (MONO) (MONO) (MONO)
L
TV AS CENTER
AUDIO
R
AUDIO
TO HI-FI
R
VCR
18
CableCARD
(Top of card faces right)
HDMI 1
OPTICAL OUT
Digital Audio
Upgrade Card
Apparatus Claims of U.S. Patent Nos.
4,631,603; 4,577,216; 4,819,098;
4,907,093; and 6,381,747 licensed
for limited viewing uses only.
RS232C
1 2 3 4 5
6 7 8 9
L V
S-VIDEO