Package Contents - NETGEAR XS712T Hardware Installation Manual

- IEEE802.3ae (10GBASE Ethernet)
- IEEE802.3az (Energy Efficient Ethernet)
- IEEE 802.3x (full-duplex flow control)
• AutoSensing and autonegotiating capabilities for all ports.
• Auto Uplink™ on all ports to make the right connection.
• Automatic address learning function to build the packet-forwarding information table. The
table contains up to 32K Media Access Control (MAC) addresses.
• Store-and-forward transmission to remove bad packets from the network.
• Full-duplex IEEE 802.3x pause frame flow control.
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per-port LEDs and Power LED.
• Internal open frame power supply.
• Standard NETGEAR 7xx series chassis (1U high).

Package Contents

The following figure shows the package contents of the smart switch.
Link/Act Mode
Power Power
Green=Link at 1G
Fan Fan
Yellow=Link at 10/
100M
Stack
Master
ID
Reset Reset Factory Factory
Defaults Defaults
Figure 1. Package contents
Verify that the package contains the following:
• XS712T Smart Switch
XS712T Smart Switch
7
SFP
+
Green=10G Link Yellow=1G
Blink=ACT