Assembly; Important Assembly Tips - One Stop Gardens 69893 Owner's Manual

Assembly

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
IMPORTANT–READ THE FOLLOWING CAREFULLY BEFORE PROCEEDING
• The first step in assembly is to assemble a proper base. The greenhouse
must be properly supported to help prevent property damage and injury in
the event of strong winds or inclement weather. Wind and ground conditions
may vary from site to site, and may affect the practicality and effectiveness
of anchoring methods substantially. If you have any doubt regarding the
stability of the base/foundation you are to use, consult a professional.
• It is always your responsibility to ensure that the greenhouse is properly anchored.
Harbor Freight Tools cannot be held responsible for personal injury,
damage to the greenhouse, or other property damage that occurs
as a result of improperly anchoring the greenhouse.
• Be certain to check with local authorities to obtain all required building permits
and to familiarize yourself with any building codes that may apply.
• Decide on a location for the greenhouse. The location should optimally
be a level, well-lit area that is sheltered from the wind. The door of the
greenhouse should not open towards the prevailing wind, if possible.
• Assemble Bolts with their heads facing the outside of the
greenhouse, unless stated otherwise. Tighten Nuts (67) only about
1/4 turn past finger-tight; be careful not to overtighten.
• Lay out all parts by number prior to assembly.
• At least two assistants will be necessary during assembly.
• Assemble on a clear, calm day. Wind will damage the
Greenhouse and make assembly difficult.
Item 69893

IMPORTANT ASSEMBLY TIPS

For technical questions, please call 1-800-444-3353. Page 5