Do you have a question about the 69893 and is the answer not in the manual?
Questions and answers
Gene
May 4, 2025
I don't have all the parts to connect 9 & 10 crown parts. I think there should be some braces to hold them together. I only found one... look at page 30.
1 comments:
Mr. Anderson
May 17, 2025
To connect Crown parts 9 and 10 for One Stop Gardens part number 69893, you need:
- 2 Normal Bolts (part 65) - Assistance to raise the completed Crown (parts 10 and 11) underneath the tops of the Crown Beams (parts 8 and 9)
The Crown is bolted in place on the bottom of the Beams using the bolts.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury. Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. Addresses practices not related to personal injury. Page 2 For technical questions, please call 1-800-444-3353. Item 69893...
″ W x 31 ″ L Door Dimensions ″ H x 35 ″ W x 1 ″ Thick Aluminum Frame Materials Transparent Polycarbonate Sheets Aluminum Thickness 0.038″ Polycarbonate Sheet Thickness 0.165″ Page 4 For technical questions, please call 1-800-444-3353. Item 69893...
• It is always your responsibility to ensure that the greenhouse is properly anchored. Harbor Freight Tools cannot be held responsible for personal injury, damage to the greenhouse, or other property damage that occurs as a result of improperly anchoring the greenhouse.
Page 7
The gravel should reach up to about corners of the base. Use Base Bolts (68), 1″ below the lip of the base. Base Nuts (69), and Connectors (45, 46) to secure the pieces together. Item 69893 For technical questions, please call 1-800-444-3353. Page 7...
Page 9
8. Secure the Rear Floor Plates (5, 6) to the Base Plates (44) using 2 Hold-down Connectors (47) in the locations shown; see illustration and inset on facing page. Item 69893 For technical questions, please call 1-800-444-3353. Page 9...
Page 13
Corner Post (7) at this point. the Side Ceiling Plate (12). 3. Secure in place with 6 Normal Bolts (65) and 6 Nuts (67). Edge-on view Top-outside view Top-inside view Ceiling Plate Assembly Item 69893 For technical questions, please call 1-800-444-3353. Page 13...
Page 15
Bolt, and secure with a Nut (65). of the Rear Braces (31) are pointing towards the Corner Posts (7). 3. Secure the other end of that Side Ceiling Plate (12, 13) similarly. Item 69893 For technical questions, please call 1-800-444-3353. Page 15...
Page 17
Bolts (66) into the slot of that Post. not equal, adjust the frame as needed until square. Some Nuts (67) may need to be loosened to adjust the frame. Tighten all Nuts after adjustment. Item 69893 For technical questions, please call 1-800-444-3353. Page 17...
Page 19
5. Place the Gutter End Caps (73) onto the ends of the Side Ceiling Plates (12, 13) oriented with a gap in the bottom to allow water to drain out of the gutters. Item 69893 For technical questions, please call 1-800-444-3353. Page 19...
Page 21
7. Attach an End Cap (72) to the top outer the Corner Brackets (49) and on the corner of each Crown Beam (8, 9). inside of the Posts (16-23). Edge-on view Top-right view Top-left view Crown Beam Assembly Item 69893 For technical questions, please call 1-800-444-3353. Page 21...
Page 23
Note that the Window Stop (50) and flat side of the Window Support Beam (42) are both facing the inside of the greenhouse. Thread Nuts (67) onto the Normal Bolts (65) and finger tighten them for now. Item 69893 For technical questions, please call 1-800-444-3353. Page 23...
Page 24
Nuts (67). Press on the heads of the Bolts through the Window Pane to allow the Nuts to thread on properly. (View from underneath window, flat side of pieces.) Page 24 For technical questions, please call 1-800-444-3353. Item 69893...
Page 25
Beam (42) in place and slide the Window Support (View from end of Crown.) Beam (42) up to touch the window. Secure it in place. 8. Repeat the steps in this phase for all four windows. Item 69893 For technical questions, please call 1-800-444-3353. Page 25...
Page 27
Right Rail End Caps (74,75) onto 4. Attach the Bottom Door Frame (37) the ends of the Door Rails. to the Side Door Frames (33) using 2 Screws (70) on each side. Item 69893 For technical questions, please call 1-800-444-3353. Page 27...
2. TO CLEAN: Wipe with a damp cloth, using a mild detergent. Do not use cleaners that are combustible, corrosive, or not compatible with aluminum. 3. WHEN STORING: Keep the Greenhouse in a box and in a clean, dry location. Item 69893 For technical questions, please call 1-800-444-3353. Page 29...
Side Post 6′ 4″ Rear Brace 5′ 10″ Rafter 5′ 11″ Front Brace 2′ Rear-Left Post 7′ 9″ Side Door Frame 6′ 1″ Rear-Right Post 7′ 9″ Door Slider 2′ 6″ Page 30 For technical questions, please call 1-800-444-3353. Item 69893...
Page 31
Panel x 3′ 6″ .4″ 2′ x Floor Plate Wall Panel Bracket 6′ 4″ 2′ x Roof Window Straight Bracket Panel 3′ 6″ Roof Panel 2′ x 6′ Crown Bracket Item 69893 For technical questions, please call 1-800-444-3353. Page 31...
Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.
Need help?
Do you have a question about the 69893 and is the answer not in the manual?
Questions and answers
I don't have all the parts to connect 9 & 10 crown parts. I think there should be some braces to hold them together. I only found one... look at page 30.
To connect Crown parts 9 and 10 for One Stop Gardens part number 69893, you need:
- 2 Normal Bolts (part 65)
- Assistance to raise the completed Crown (parts 10 and 11) underneath the tops of the Crown Beams (parts 8 and 9)
The Crown is bolted in place on the bottom of the Beams using the bolts.
This answer is automatically generated