Using Vcr Plus+ To Record A Program - Hitachi VT-M284A Owner's Manual

Basic Operations (VCR Plus + Recording)

Using VCR Plus+ to Record a Program

Now that your channels are set up, you can take advantage of this quick and easy
method of delayed recording. You will use the on-screen Easy Guide System, following
the basic procedure for delayed recording outlined on page 37. See the section on
Recording a Program for recording tips and programming priorities.
You set up the delayed recording using the on-screen Easy Guide System.
1. Press GUIDE, then press 1 to select VCR PLUS RECORDING and bring up this
screen:
2. Use the number buttons to enter the PlusCode of the program you want to record.
This code can be up to eight digits. If you enter a wrong digit, press CLEAR and enter
the correct one.
3. If you accidentally enter a nonexistent PlusCode, the VCR gives you an error
message that disappears from the screen in about 10 seconds.
4. If you have entered the correct PlusCode, press GUIDE to store the PlusCode in the
VCR's memory. This brings up another screen:
5. Press number buttons 1, 2, or 3 to select ONE TIME, DAILY, or WEEKLY
RECORDING.
Important: Programming does not take effect unless you select one of these options.
6. When the next screen comes up, choose between standard or extended tape speed
by pressing the 5 button. This is also a good time to check the channel number-- it
should be the one on which you usually watch the program at home. (If not, you need to
check your VCR Plus+ channel setup.)