Table of Contents
Advertisement
Care and Servicing (Problems)
TV program cannot be viewed Loose or inappropriate
Poor- picture ("noise") quality.
No picture during playback.
TV cannot be operated by the
VCR's remote control.
Mechanical sounds during
stop mode.
Cannot store tape date in
Navigation Menu.
connection
TV channel selector on the
proper channel?
Is TV correctly tuned?
Static lines through the
picture?
"Noisy" picture despite all
previous adjustments, even
when playing different
cassettes?
TV set to the correct video
viewing channel?
Is VCR remote control
programmed for your TV?
Is remote control set to control
the TV?
Has a loaded cassette been
stopped more than 5 minutes?
Was 1 TAPE NAVIGATION
<OFF> specified in the TAPE
NAVIGATION MENU?
Is the recording time too
short?
Is tape data memory full.
Review hookup directions and
make correct, firm
connections.
Set TV to channel 3 or 4 as
correct for your area during
playback. (Set TV to AUX or
video if you have a direct
video hookup.)
Fine tune the TV.
Press 1 or 4 button to adjust
tracking.
Have video heads cleaned by
a qualified service technician.
Set TV to channel 3 or 4.
Follow instructions in
Advanced Operations to
program the remote control to
send signals that your TV can
recognize.
Press the TV device button,
then press the button
corresponding to the TV
function you want.
Nothing is wrong. The tape
protection mechanism is
working. Eject the cassette if
you are done viewing.
Otherwise, no action is
necessary.
Switch it to <ON>
Data is not stored in memory
when the recording time is
less than 5 minutes (less than
5 minutes (less than 15
minutes in EP mode).
Delete unnecessary tape data.
75
Advertisement
Table of Contents
