When Scansnap Manager Does Not Operate Normally; Removing Unnecessary Icons From The Taskbar; Checking The Connection Between The Scansnap And The Computer - Fujitsu ScanSnap S1500 Installation & Troubleshooting Manual

When ScanSnap Manager does not operate
normally
If the ScanSnap Manager icon is displayed as
connected the ScanSnap to the computer, perform the following procedures.
In Windows 7, the ScanSnap Manager icon
you click

■ Removing unnecessary icons from the taskbar

1.
Check the software icons on the taskbar, and exit the software that you
are not using.
The icon is removed from the taskbar.
2.
Right-click the ScanSnap Manager icon
[Exit].
3.
Start up ScanSnap Manager again by selecting [Start] menu
[All Programs]
If the problem persists, refer to the next topic
computer" (page
■ Checking the connection between the ScanSnap and
the computer
1.
Unplug the USB cable from the computer and the ScanSnap, then plug it
back in.
Make sure to leave at least five seconds between unplugging and plugging the cable.
If you are using a USB hub, connect the USB cable to the computer directly.
If the problem persists, refer to the next topic
(page 26).

When ScanSnap Manager does not operate normally

on the taskbar.
[ScanSnap Manager]
25).
even though you installed the software and
is displayed in the menu which appears when
on the taskbar, and select
[ScanSnap Manager].
"Checking the connection between the ScanSnap and the
"Checking if ScanSnap Manager is operating normally"
25