Power Source - Hitachi L26D204 Owner's Manual

Lcd hdtv with built-in dvd player
Hide thumbs Also See for L26D204:
Table of Contents

Advertisement

Remote control
Inserting Batteries
1
Open the battery compartment cover in
the direction of the arrow.
Operation
Aim the remote control at the remote sensor and press control
buttons to operate.
Operate the remote control within a 30° angle on either side of
the remote sensor, up to a distance of approximately 15 feet.
NOTE:
Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.
The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote sensor may shorten
operating distance.
Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries properly.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable, (ni-cad, ni-mh, etc) batteries.
Remove batteries if the remote control will not be operated for an extended period of time.
Please use caution when inserting batteries to avoid battery damage. If the spring terminal in the remote control remains in contact
with a side of a damaged battery it can cause a short circuit. Never use damaged batteries as they can become very hot and are
dangerous.

Power source

TO USE AC POWER
1.
Connect the AC cord plug into this unit's AC IN jack.
2.
Connect the AC cord into an AC outlet.
NOTE:
Please make sure to insert the cord securely at both the LCD TV/DVD and the wall outlet.
The AC Cord has a polarized type AC line plug. If the supplied AC cord does not match your AC outlet, contact a qualified electrician.
WARNING:
DO NOT CONNECT THIS UNIT TO THE POWER USING ANY DEVICE OTHER THAN THE SUPPLIED AC CORD. THIS COULD
CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.
DO NOT USE WITH A VOLTAGE OTHER THAN THE POWER VOLTAGE SPECIFIED. THIS COULD CAUSE FIRE, ELECTRICAL
SHOCK, OR DAMAGE.
CAUTION:
WHEN THIS UNIT IS NOT USED FOR A LONG TIME, (E.G., AWAY ON A TRIP) IN THE INTEREST OF SAFETY, BE SURE TO
UNPLUG IT FROM THE AC OUTLET.
DO NOT PLUG/UNPLUG THE AC CORD WHEN YOUR HANDS ARE WET. THIS MAY CAUSE ELECTRICAL SHOCK.
IF YOU NEED TO REPLACE THE SUPPLIED AC ADAPTER OR AC CORD, THE SPECIFIED ONE IS RECOMMENDED. CONTACT
THE DEALER THAT YOU PURCHASED THE UNIT FROM.
12
54H0321A_eng.indd 12
54H0321A_eng.indd 12
2
Install two "AA" batteries, paying
attention to the polarity diagram in the
battery compartment.
AC cord (supplied)
3
Replace the compartment cover.
Approximately 15 feet
AC Outlet
Wider Hole
and Blade
AC 120V, 60Hz
(continued)
5/4/10 3:44:29 PM
5/4/10 3:44:29 PM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents