Emotiva Airmotiv 4 Owner's Manual page 28

Problem: Low but undistorted sound
• Verify that the Level controls on both (or all) monitors are in their calibrated
positions.
• Check your signal source.
Problem: Unbalanced sound or poor imaging
• Verify that the Level controls on both (or all) monitors are in their calibrated
positions.
• Verify that the rear panel equalization controls, which are used to compensate for
speaker position and room acoustics, are set in the same position for each monitor.
In general, although some situations may demand unusual settings, the best
performance will be achieved if the equalization controls on symmetrical pairs of
monitors, such as a single pair of monitors or a pair of surrounds, are set the same.
If not, uneven frequency response and poor imaging may result.
Problem: No sound from only one transducer
• If the power indicator is flashing red frequently, this indicates that the protection
circuitry is engaging frequently, which may result in intermittent or distorted sound.
If you are playing the monitor at excessively loud levels, then you should reduce
the volume level.
• Check your signal source.
• Try swapping monitors. If the problem is definitely associated with one unit, then
contact Emotiva Technical Support.
Page 26