CHANNEL SELECTOR FOOTSWITCH
Your new LWA 1000 comes with a footswitch and supplied cable provided for remote channel switching capability. Simply route your
instrument through the footswitch and connect to one of the amplifier inputs.
1.
IN – Use a standard guitar cable to connect your instrument to the input of this unit.
2.
OUT – Use the provided TRS (tip-ring-sleeve) cable for connecting the footswitch to any of the two inputs on the
LWA 1000. Any of the two inputs can be used to connect the footswitch and the choice of input does not affect
functionality in any way.
3.
CH1/CH2 – Toggles between Channel 1 and Channel 2.
SETUP GUIDE
1.
Unpacking – Carefully unpack unit from the carton box.
2.
Powering up – Ensure the mains power switch is in
the AC Mains socket of the amplifier to the mains power outlet. Now flip the power switch on the amplifier to the
ON
position.
"
"
3.
Connecting speaker cabinets – Connect speaker cabinet(s) to the SPEAKER OUT using a compatible speaker cable.
This minimum recommended speaker load is 4.
4.
Connecting an instrument – Always mute the channel(s) you wish to plug in your instrument before inserting the
input jack(s). Now connect your bass(es) to the appropriate input(s) on the front panel.
5.
Adjust the input gain knob for a good signal level.
6.
Adjust EQ/Compressor settings to your liking.
7.
Set the Volume knob so that the output volume is at a reasonable level.
8.
Rock out!
2
ARTICLE NUMBER:
OFF
position and then connect the supplied power cord from
"
"
10
1
3
W A LWA 2S