Max ADVANTAGE 831.153962 User Manual page 11

19. Wrap the Long Cable (80) under a 90mm Pulley
(28) as shown. Attach the Pulley and a Pulley
Guard (29) to the Upright (3) with a 3/8" x 4 1/2"
Button Bolt (40) and a 3/8" Nylon Locknut (76).
Make sure the flat edge of the Pulley Guard is
on the bottom.
20. Attach a Pulley Housing (94) to the indicated "U"-
channel on the 10-pound Center Resistance Bar
(44) with a 3/8" x 4" Button Bolt (24), two Pivot
Bushings (74), and a 3/8" Nylon Locknut (76).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Pulley
Housing (94) with a 3/8" x 1 1/2" Button Bolt (71)
and a 3/8 Nylon Locknut (76).
21. Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley and a Pulley Guard (29) to
the indicated 3/8" x 5 1/2" Carriage Bolt (73) with
a 3/8" Nylon Locknut (76). Make sure the flat
edge of the Pulley Guard is on the side
shown.
22. Make sure there are no resistance bars under the
"U"-channels on the 10-pound Center Resistance
Bar (not shown). Have a second person pull on
the Long Cable (80) to create slack in the Cable.
Insert the end of the Long Cable (80) through the
welded tube on the indicated end of the Cross
Tube (11) and then through the remaining Swivel
Arm (22). Make sure the Cable is on the indicat-
ed side of the welded rod in the Swivel Arm.
Insert the Swivel Arm (22) into the welded tube
on the Cross Tube (11). Secure the Swivel Arm
with a #8 x 3/8" Screw (107).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm
(22) with a 3/8" x 1 1/2" Button Bolt (71) and a
3/8" Nylon Locknut (76).
19
3
40
20
44
74
94
24
71
21
28
80
Flat
Edge
22
22
Rod
80
28
76
11
28
76
29
80
Flat
Edge
74
76
76
28
80
29
76
73
71
107
11