Advertisement
Festive Light Pak™
MULTI FLOWER
Power Supply:
be sure the source voltage in your area match-
es the required voltage for your American DJ
Moonflower™ before attempting operation.
See the next page for lamp relplacement and
breaker reset.
General Operation:
and watch it go. This fixture is designed to
operate as a stand alone unit. It has been tested and the lamp has
been installed at the factory, there is no assembly necessary. The
Multi Flower™ is ready to be plugged in, out of the box, there is no
power switch. If there is no lamp output check the fuse and bulb. If
the fuse and bulb are good, please return the unit for servicing.
Operating Modes:
This unit comes with a 3-way multi-operating switch located on
the rear of the unit. The switch controls three (3) different operating
modes
Switch in the "I" position: Mode 1 - In this mode the dichoric dish will
spin continuously, regardless of the presence of sound.
Switch in the "0" position: Mode 2 - In this mode the dichroic dish
will remain static.
Switch in the "II" position: Mode 3 - In the this mode the dichoric
dish will only rotate in the prescence of sound. Please note that tap-
ping on the unit, or high pitched sounds may not trigger the unit, the
unit is designed to react to low frequencies (bass). Also note that the
music sensitivity is preset at the factory and may not be changed or
adjusted.
American DJ
- www.americandj.com - Festive Light Pak™ Instruction Manual Page 5
©
®
Multi Flower™ Operation
Before plugging your unit in,
Just plug this light in,
Multi Flower™
Halogen Lamp Warning:
with a halogen lamp which is highly susceptible
to damage if improperly handled. Never touch the
lamp with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
®
fixture until the lamp has had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
Caution:
Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning:
If, after replacing; the lamp continues to blow, STOP using
the unit. Contact customer support for further instructions, you may
have to return the unit for servicing. Continuing to use the unit may
cause serious damage.
Breaker Reset:
This unit is equipped with a built-in safety breaker.
This breaker is designed to close the power circuit in the event of an
internal short or power surge. This will reduce the risk of electrical
shock or fire and protect the circuitry. To reset the breaker, push the
breaker button in until you hear it "pop" back in to place. If the break-
er continues to pop, stop using the unit and contact our customer
support team, the unit may need to be returned for service.
Lamp Installation/Replacement:
change the lamp while the fixture is plugged in. Always disconnect
the main power and allow the unit ample time to cool before attempt-
ing to replace the lamp.
1. Be sure to follow the proper handling procedures that deal with
halogen lamps.
2. Remove the phillips screw at the top front of the unit that holds
the units top case in place.
3. After removing the phillips screw, pull up the case of the unit to
expose the lamp socket assembly.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble in reverse
order.
American DJ
- www.americandj.com - Festive Light Pak™ Instruction Manual Page 6
©
®
Lamp Installation/Replacement
This fixture is fitted
technician. Replace
®
Caution! Never attempt to
Advertisement
