Advertisement
Rover II™
General Operation:
This fixture is designed to operate as a stand alone unit, there is no
need of a controller. It has been tested and the lamp installed at the
factory there is no assembly necessary. The Rover II™ is ready to be
plugged in, out of the box. There is no power switch, after plugging
the unit if there is no lamp output check the fuse and bulb. If the fuse
and bulb are good, please return the unit for servicing. After plugging
this fixture in, the units X-axis mirror will move back and forth. The
Electra II™ features a multi-color dichroic dish that will also rotate.
This fixture features a light weight case design and a hanging brack-
et. This unit can be operated in three different modes. This fixture is
designed for mobile DJ's, clubs, bands, roller rinks and any arena that
requires a compact, light weight, easy to use fixture.
Operating Modes:
This unit comes with a 3-way multi-operating switch located on
the rear of the unit. The switch controls three (3) different operating
modes; Static, Sound Active, and Continuous Rotation. When the
switch is in the "I" position the internal dichroic dish spin continu-
ously and the mirror will react to sound, via its internal microphone.
When the unit is in the "0" position the internal dichroic dish is static
(does not rotate) and the mirror will react to sound. When the switch
is in the "II" position the unit's internal dichroic color wheel and mirror
will react to sound.
American DJ Supply
- www.americandj.com - Rover II™ Instruction Manual Page 3
©
®
Operation
3 Position Mode Switch
Fuse Holder
Power Cord
Electra II Bottom Housing
Rover II™
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the
internal and external optical lenses must be carried out periodically to
optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing.
2. Use a brush to wipe down the fan grill.
3. Clean the external optics with glass cleaner and a soft
cloth every 20 days.
4. Clean the internal optics with glass cleaner and a soft cloth
every 30-60 days.
5. Always be sure to dry all parts completely before plugging
the unit back in.
Cleaning frequency depends on the environment in which the fix-
ture operates (I.e. smoke, fog residue, dust, dew). In heavy club use
we recommend cleaning on a monthly basis. Periodic cleaning will
ensure longevity, and crisp output.
Rover II™
Fuse Replacement:
Disconnect from the main power supply. Insert
a standard flat head screw driver in to the fuse holder housing as illus-
trated in figure two. Turn the screwdriver in counter-clockwise direction
to remove the fuse holder. Remove the old fuse and discard it, replace
the fuse with the same type. Insert the fuse back into it's housing.
If you continue to blow fuses, STOP using the unit. Returning the unit
for servicing. Continuing to use the unit may cause serious damage.
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
cian.
American DJ Supply
- www.americandj.com - Rover II™ Instruction Manual Page 4
©
®
Cleaning
Fuse Replacement
techni-
®
Use a flat head screwdriver to
remove the fuse holder
Advertisement
