Hitachi 27CX01B User Manual page 39

OPERATION OF REMOTE CONTROL
Then release both buttons.
(3) Within ten seconds after releasing RECALL and CH DOWN (
code number using REMOTE KEYPAD (refer to list).
• The remote control is now ready to send commands to your VCR.
Some brands have more than one remote code listed due to changes in the remote codes from early to later
model years, or due to format differences (VHS/BETA). In such cases, you may have to try more than one code to
find the code your VCR accepts.
NOTE:
Depending on the model, year produced, brand, and type of VCR, some models may not be compatible with the
remote control.
TO IDENTIFY YOUR VCR - SEARCH METHOD.
(1) Slide TV-CATV switch on the remote to TV.
(2) Press POWER on the VCR to On.
(3) Stand at least six feet away from the front of the VCR.
Point the remote towards the VCR.
Hold down RECALL and CH UP (
(4) Watch the Channel Number indicator on the VCR, Channel numbers will scan up when the VCR has been
identified.
Release RECALL and CH (
The VCR's remote control code number has been identified, and the remote is ready to operate the VCR.
TIPS ON IDENTIFYING YOUR VCR:
If your VCR model does not have the CHANNEL UP function on its remote control, it cannot be identifed
using the SEARCH method of identifying. For such models, please try theDIRECT ENTRY method of
identifying.
Be Patient: a minute or two can seem a lot longer when you're waiting for something to happen, but the
code should be identified within two minutes. Remember, it is only a one-time set-up.
Be careful not to let the VCR scan more than five channels when the indicator starts to move up. If you
continue holding down the RECALL and CH UP (
be passed up, and the two minute identify cycle will have to be repeated.
If a channel change does not occur on the VCR within two minutes, read the identifying instructions again
and repeat the steps. Should a channel change still not occur the remote will not operate with the desired
VCR..
HOW TO IDENTIFY A CABLE CONVERTER
n
TO IDENTIFY YOUR CABLE CONVERTER - DIRECT ENTRY METHOD.
) at the same time. KEEP HOLDING THE BUTTONS DOWN.
) as soon as the channel numbers start to scan up.
), enter your VCR's two-digit remote control
) after five channel scans, the proper remote code can
39