Assembling Your Blender - Back to Basics BLENDER SOLUTION Instruction Manual

To prevent personal injury or property damage, read and follow all instructions
and warnings.
•
Never leave the house while the appliance is on.
•
A short power-supply cord is provided to reduce risks resulting from becoming
entangled in or tripping over a longer cord.
•
Longer, detachable power-supply cords or extension cords are available and
may be used if care is exercised in their use. While use of an extension cord is
not recommended, if you must use one, the marked electrical rating of the
detachable power-supply cord or extension cord should be at least as great as
the electrical rating of the appliance. If the appliance is of the grounded type, the
extension cord should be a grounding-type 3-wire cord. The cord should be
arranged so that it will not hang over the counter top or tabletop where it can be
pulled by children or tripped over.
•
After running the motor continuously for ninety seconds, wait at least three
minutes before running the motor again.
•
This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit into a polarized outlet
only one way. If the plug does not fit fully into the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. Do not attempt to modify the plug
in any way.
•
To reduce the risk of injury, never place cutter-assembly blades on base without
blending jar properly attached.
•
For household use only.
SAVE THESE INSTRUCTIONS
Before assembling your blender, wash all parts, except for the motor base in
warm, soapy water, rinse thoroughly and dry. Unscrew and disassemble the valve
for cleaning (see Cleaning Your Appliance section). To prolong the life of your
appliance, do not wash parts in the dishwasher.
1. Position the rubber gasket down onto the circular flat surface in the blender or
smoothie blade base.
2. Screw the blade base onto the bottom of the blending jar by twisting the blade
base clockwise until tightened. Make sure that the blade base is tightly fastened
to the blending jar and that the rubber gasket is properly compressed between
the blending jar and the blade base.
A
SSEMBLING
Y B
OUR LENDER
3