Electrolux RWP 107109 W User Manual page 9

2. Connect the hose with the angled con-
nection to the machine. Do not place
the inlet hose downwards. Angle the
hose to the left or right depending on
the position of your water tap.
35°
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4"
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
Water drainage
Form a hook at the end of the drain hose
using the plastic hose guide, if necessary.
The end of the drain hose can be posi-
tioned in four ways:
• Hooked over the edge of a sink using
45°
the plastic hose guide.
Tie the plastic hose guide to the tap with
a string to prevent that the drain hose un-
hooks when the appliance is emptying.
• Onto a sink outlet spigot.
Push the drain hose onto the spigot and
secure with a clip, ensure a loop is
formed in the drain hose to prevent
waste from the sink entering the appli-
ance.
If the outlet spigot has not been used be-
fore, remove any blanking plug that may
be in place.
• Directly into a drain pipe at a height
of not less than 60 cm and not more than
100 cm. The end of the drain hose must
always be ventilated, i.e. the inside di-
ameter of the drain pipe must be larger
electrolux 9